Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


KPM Fuel Systems


Page 1 of 4 1 234
Showing results 1 to 30 of 109
Search took 0.01 seconds. Search: Posts Made By: SpeZ
Forum: 6th gen Camaro 1LE Yesterday, 12:23 PM
Replies: 9
Views: 251
Posted By SpeZ
Hmm weird. But I can tell you its probably...

Hmm weird.
But I can tell you its probably normal to see eLSD lockup at the start.
When I give the engine rpm in park I also see like 20-30% lockup.
Forum: 6th gen Camaro 1LE Yesterday, 07:19 AM
Replies: 9
Views: 251
Posted By SpeZ
Bleed events - Because the eLSD system is filled ...

Bleed events - Because the eLSD system is filled
with fluid, small amounts of air will accumulate in
the system over time. A small actuator is built into
the system in order to bleed these small...
Forum: Tuning / Diagnostics 11-21-2025, 10:00 AM
Replies: 6
Views: 1,889
Posted By SpeZ
Every time you try to read the TCM tune it will...

Every time you try to read the TCM tune it will give you a stock file for your vehicle.

@bishopts Shift points are based on vehicle speed.
Forum: ZL1 Discussions 10-12-2025, 01:33 AM
Replies: 22
Views: 1,210
Posted By SpeZ
Definitely not caused by overfilling. If I'd...

Definitely not caused by overfilling.
If I'd had to take a guess then I stick with a faulty front crank seal.
Forum: Transmissions 10-03-2025, 02:33 PM
Replies: 3
Views: 545
Posted By SpeZ
I've been using the oem fluid all the time. It is...

I've been using the oem fluid all the time. It is very cheap.
But next time I will use a quality fluid like Amsoil.

Since you own a 2021 model, you have a gen2 10l90 with couple of small...
Forum: Transmissions 10-02-2025, 09:34 AM
Replies: 3
Views: 545
Posted By SpeZ
10l90 issues/infos

Hey guys,

with the 10l90 in my ZL1 I encountered already a few misshifts. It is very rare but usually happens at like 50 mph at WOT. After it shifts, it rev limits at like 4500 rpm and does...
Forum: Road Course/Track and Autocross 08-31-2025, 11:44 AM
Replies: 28
Views: 2,049
Posted By SpeZ
Just keep in mind, you don't have the auxiliary...

Just keep in mind, you don't have the auxiliary engine coolant cooler on the LT1 trim.
As wells as no differential or transmission cooler.
The LT1 trim is the base V8 model and is not intended for...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 08-31-2025, 11:38 AM
Replies: 19
Views: 2,963
Posted By SpeZ
I only use the OEM, which is the PF64. Genuine...

I only use the OEM, which is the PF64. Genuine quality with tested and safe bypass pressures.
Forum: Road Course/Track and Autocross 08-18-2025, 09:28 AM
Replies: 18
Views: 2,721
Posted By SpeZ
I'd say because the SPL arms have spherical...

I'd say because the SPL arms have spherical bushings made out of steel for maximum stiffness. Definetly an upgrade. I doubt that the bang for the buck is worth. For myself, I will stick to the FEA...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 08-17-2025, 06:14 AM
Replies: 13
Views: 1,187
Posted By SpeZ
Big cap. No one ever would replace the head...

Big cap. No one ever would replace the head gasket, except it went bad.
It prolly overheated once, thats the reasons.
Makes no sense, that they used bad gaskets for canada fellas, cuz they got a...
Forum: Road Course/Track and Autocross 08-16-2025, 01:50 PM
Replies: 18
Views: 2,721
Posted By SpeZ
Good mention here, but for me my passenger...

Good mention here, but for me my passenger control arm leaked and the track where I only drive goes clockwise, so the rumble strips are on driver side at all times, except in one turn. Just for short...
Forum: Road Course/Track and Autocross 08-16-2025, 09:41 AM
Replies: 18
Views: 2,721
Posted By SpeZ
I literally wanted to order new arms right now...

I literally wanted to order new arms right now because I got slight play at the driver side wheel.

Just saw this topic and I have since last year this dark hydraulic fluid on the passenger side...
Forum: ZL1 Discussions 08-16-2025, 02:18 AM
Replies: 22
Views: 2,611
Posted By SpeZ
Awesome, another Callaway SC750. I can...

Awesome, another Callaway SC750.
I can recommend a software tune anyway, tune on my car was dogshit and was just a little above stock ZL1 power. Same was with another SC750 here in the forum I...
Forum: ZL1 Discussions 07-31-2025, 09:39 AM
Replies: 10
Views: 1,706
Posted By SpeZ
Unfortunately you can not chose the speed limit. ...

Unfortunately you can not chose the speed limit.
Only way would be to load up a changed tune before.
In general I'd highly recommend to programm and make use of the temperature based cutoff. So...
Forum: Camaro DIY & HOW-TO instructions & discussions 07-22-2025, 06:34 PM
Replies: 3
Views: 5,870
Posted By SpeZ
I am located in germany. Around 7 track hours...

I am located in germany.
Around 7 track hours in total with it.
And lots of high speed driving on the autobahn.

So far, I am very happy with the results. Next weak spot would be transmission oil...
Forum: Camaro DIY & HOW-TO instructions & discussions 07-21-2025, 06:05 PM
Replies: 3
Views: 5,870
Posted By SpeZ
Small update after plenty of time in use. Oil...

Small update after plenty of time in use.
Oil drain back into the pan does not happen.
When doing oil changes and you remove the oil filter, the "Siphon effect" starts and pretty much all oil in...
Forum: Road Course/Track and Autocross 07-21-2025, 05:57 PM
Replies: 49
Views: 5,743
Posted By SpeZ
I run the stock oil cooler combined with the 25...

I run the stock oil cooler combined with the 25 row cooler from mishi.
+1 for mishi. Solid quality and works pretty much the same.
I ordered all the single parts and replaced it with the driver...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 07-14-2025, 03:51 AM
Replies: 7
Views: 963
Posted By SpeZ
Engine usually turns off after like 15-20 minutes...

Engine usually turns off after like 15-20 minutes in park and has safety reasons.


But the same problem had someone in my area just a few months ago, even after replacing the BCM and the start...
Forum: Suspension | Brakes | Chassis 07-11-2025, 08:29 AM
Replies: 62
Views: 24,276
Posted By SpeZ
Revived an old thread, but it might help somebody...

Revived an old thread, but it might help somebody in the future.

ZL1 sway bar (FE4) combined with the DSSV makes the suspension extremely! stiffer. Literally has only downsides and disrupts weight...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 07-06-2025, 02:47 PM
Replies: 16
Views: 8,988
Posted By SpeZ
Update: The second throttle body which was...

Update:
The second throttle body which was brand new just started to malfunction after just like 12 months.
Replaced with another brand new LT5 TB and no issues anymore.
Running now on the third...
Forum: ZL1 Discussions 07-01-2025, 10:35 AM
Replies: 15
Views: 556
Posted By SpeZ
Catalytic converters in good condition are worth...

Catalytic converters in good condition are worth like 400-800$.
I paid 800$ few weeks ago for both primary cats needed for inspection.
Mine were empty after track driving.
Forum: Road Course/Track and Autocross 06-25-2025, 01:18 AM
Replies: 19
Views: 2,527
Posted By SpeZ
Motul RBF 600 is the best in terms of highest...

Motul RBF 600 is the best in terms of highest boiling point if fluid is free of water or fresh.
Castrol SRF is close, but both are high tier.

I personally use a "mid" tier for a lot less money...
Forum: Dragstrip and Launching Discussion 06-21-2025, 05:03 AM
Replies: 14
Views: 1,596
Posted By SpeZ
Many tunes break the launch control. Either...

Many tunes break the launch control.
Either Wheelhop control or the traction control or maybe both need to stay enabled in HpTuners.
Otherwise it won't limit to the target rpm.
Forum: Road Course/Track and Autocross 06-20-2025, 01:24 PM
Replies: 16
Views: 4,503
Posted By SpeZ
@BobLadd58 My resistor did not work for long...

@BobLadd58
My resistor did not work for long time. I had several days later the "service suspension" again.

But FE3 (SS) and FE4 (ZL1) magnetic ride may work different, I know a few who don't...
Forum: ZL1 Discussions 06-07-2025, 01:26 PM
Replies: 30
Views: 1,936
Posted By SpeZ
2017 workshop manual says .037-.043" gap on stock...

2017 workshop manual says .037-.043" gap on stock LT4.
I am at 14.5 psi, .037" gap with the NGK 6510 and have zero issues wether cold or on track.
Forum: Suspension | Brakes | Chassis 06-07-2025, 01:01 AM
Replies: 7
Views: 1,378
Posted By SpeZ
Front rotor: 13528522 Rear rotor: 85589611 ...

Front rotor: 13528522
Rear rotor: 85589611
Front pad kit: 84732488
Rear pad kit: 84732503

I buy my stuff usually at rockauto.
Front rotor has a minimum thickness of 1.06 inch.
Forum: Road Course/Track and Autocross 06-06-2025, 01:54 AM
Replies: 32
Views: 4,940
Posted By SpeZ
Mobil 1 15W-50 is the goat.

Mobil 1 15W-50 is the goat.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 06-04-2025, 11:32 AM
Replies: 6
Views: 1,229
Posted By SpeZ
Rockauto is great, but you will be surprised by...

Rockauto is great, but you will be surprised by the shipping costs since the brake rotors are heavy and everything comes by plane.
Yea, rear pads are that expensive, no clue. But other shops want...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 06-04-2025, 01:17 AM
Replies: 6
Views: 1,229
Posted By SpeZ
J6G is 339 mm on the rear and 345 upfront. In...

J6G is 339 mm on the rear and 345 upfront. In 2023 I replaced the brakes on my 2016 2SS by myself.

Front: 13528522
Rear: 85589611
The brake pad part numbers are correct.
Forum: 6th gen Camaro 1LE 05-31-2025, 06:39 AM
Replies: 7
Views: 1,462
Posted By SpeZ
If the ptm mode menu doesn't show up right away,...

If the ptm mode menu doesn't show up right away, no worries.
When you hit the driving mode selector, the ptm mode menu appears.
Showing results 1 to 30 of 109
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -5. The time now is 08:47 PM.

Contact Us - CAMARO6 - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.