Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Bigwormgraphix


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.03 seconds. Search: Posts Made By: Megahurtz
Forum: Tuning / Diagnostics 12-30-2025, 08:35 AM
Replies: 7
Views: 315
Posted By Megahurtz
Shoot me an email with the car and the mods info....

Shoot me an email with the car and the mods info. Check my profile for my email.
Forum: ZL1 Discussions 12-27-2025, 08:50 AM
Replies: 21
Views: 842
Posted By Megahurtz
The stock pump will drive the XDI 30's to max if...

The stock pump will drive the XDI 30's to max if using a 32% fuel lobe on the cam. Unless he plans on going larger than 30% injectors, there really isn't a reason to upgrade the LT4 high side pump.
...
Forum: ZL1 Discussions 12-24-2025, 07:55 AM
Replies: 45
Views: 1,737
Posted By Megahurtz
Buy ZL1, install 2.3 upper and flex fuel sensor....

Buy ZL1, install 2.3 upper and flex fuel sensor. Have it tuned by Snackbar and drive the hell out of it. It will be a blast and faster than anything you've mentioned. It is a totally different than a...
Forum: ZL1 Discussions 12-18-2025, 10:57 AM
Replies: 7
Views: 523
Posted By Megahurtz
If you do the X port and 2.3 pulley, you will see...

If you do the X port and 2.3 pulley, you will see the best gains with a 5 inch intake and 103mm TB.

If you're going to port the blower but use the stock pulley, keep the 95mm TB.
Forum: ZL1 Discussions 12-09-2025, 06:34 AM
Replies: 21
Views: 842
Posted By Megahurtz
Not a lot because you will be out of injector...

Not a lot because you will be out of injector spray window on stock injectors. The stock LT4 high side pump is plenty to drive XDI 30's s with a fuel lobe on the cam. The DSX will feed plenty of low...
Forum: ZL1 Discussions 12-02-2025, 05:32 AM
Replies: 24
Views: 1,050
Posted By Megahurtz
Intake temp B1S3 is over 200F. I would check your...

Intake temp B1S3 is over 200F. I would check your supercharger intercooler circuit for air bubbles, failed coolant pump or if it has any coolant in it at all. A more robust scanner tool like...
Forum: ZL1 Discussions 11-19-2025, 08:23 AM
Replies: 48
Views: 2,386
Posted By Megahurtz
If you can deliver the fuel you need for the...

If you can deliver the fuel you need for the power range you're looking for with DI alone, DI will have the advantage. DI is more resistant to knock, atomizes better in the chamber(very loose way of...
Forum: ZL1 Discussions 11-18-2025, 02:00 PM
Replies: 48
Views: 2,386
Posted By Megahurtz
lol maybe I'll post pics up later in another...

lol maybe I'll post pics up later in another thread. I don't want to pull this thread off topic.
Forum: ZL1 Discussions 11-18-2025, 08:43 AM
Replies: 48
Views: 2,386
Posted By Megahurtz
I've been lurking but the forum has been kind of...

I've been lurking but the forum has been kind of slow lately. I assumed too many of these cars were getting stolen or something. I still tune GM stuff all of the time, I've just been playing in the...
Forum: ZL1 Discussions 11-17-2025, 08:57 AM
Replies: 48
Views: 2,386
Posted By Megahurtz
Personally, I always prefer DI over Port or...

Personally, I always prefer DI over Port or DI/Port blend. Also, to note, the Goliath and LPE high side pumps require different tuning in my experience.

If you can deliver the fuel you need with...
Forum: Forced Induction Discussions 11-13-2025, 09:44 AM
Replies: 25
Views: 1,080
Posted By Megahurtz
Virtual Dyno graphs are only as accurate as the...

Virtual Dyno graphs are only as accurate as the Airmass Model in the tune.
Forum: ZL1 Discussions 11-13-2025, 09:43 AM
Replies: 45
Views: 1,806
Posted By Megahurtz
I push LT4 stuff past 24 degrees all of the time...

I push LT4 stuff past 24 degrees all of the time when running Ethanol Blends. But I don't when its running pump or pump + meth or even race gas.
Forum: ZL1 Discussions 11-04-2025, 04:01 PM
Replies: 45
Views: 1,806
Posted By Megahurtz
LT4's will actually respond to more timing above...

LT4's will actually respond to more timing above 6000 RPM. Look at how the Blackwings are tuned from the factory.

But King LT1 and Katech_Mike have already shared definitive facts. Essentially it...
Forum: ZL1 Parts 11-04-2025, 06:18 AM
Replies: 24
Views: 5,672
Posted By Megahurtz
I can confirm no tuning is needed for Tony's...

I can confirm no tuning is needed for Tony's ported V1/V2/V3 OEM throttle body.
Forum: ZL1 Discussions 11-03-2025, 02:35 PM
Replies: 45
Views: 1,806
Posted By Megahurtz
Timing depends on many factors. It certainly...

Timing depends on many factors. It certainly doesn't make any sense to run no more than 2 degrees more than your boost level. Sounds like this person was just making stuff up to keep someone from...
Forum: Tuning / Diagnostics 10-19-2025, 02:03 PM
Replies: 17
Views: 3,911
Posted By Megahurtz
I wouldn't do it that way. I would copy the stock...

I wouldn't do it that way. I would copy the stock values from 0.5 column to the 0.0 column and then interpolate between column 0.0 and 1.0.

Your screenshots will likely cause a stumbling rough...
Forum: Tuning / Diagnostics 10-19-2025, 08:31 AM
Replies: 17
Views: 3,911
Posted By Megahurtz
Cat Warmup and the startup "bark" are two...

Cat Warmup and the startup "bark" are two different things. And are two different things in the tune.

Bark = The quick Rev up on startup. It lasts about half a second.

Cat Warmup = Right after...
Forum: Tuning / Diagnostics 10-18-2025, 10:20 AM
Replies: 17
Views: 3,911
Posted By Megahurtz
The cold start "bark", assuming you're talking...

The cold start "bark", assuming you're talking about the half second rev up in RPM's when you start and NOT the cat warmup where it stays loud for about 20 seconds.

The bark is controlled by...
Forum: ZL1 Discussions 10-08-2025, 08:36 AM
Replies: 29
Views: 1,749
Posted By Megahurtz
$70K would be a good offer for that car. I would...

$70K would be a good offer for that car. I would say $65K but since its a convertible its worth a little more. However, the buyer market for a convertible ZL1 is much smaller. Not many people want...
Forum: Camaro Price | Ordering | Tracking | Dealers 10-08-2025, 08:32 AM
Replies: 18
Views: 1,381
Posted By Megahurtz
They are not made anymore. A ton of them have...

They are not made anymore. A ton of them have been stolen. They are relatively cheap to make very fast. The last two years are bringing in high demand and price, which isn't unusual as they are the...
Forum: ZL1 Discussions 09-12-2025, 04:44 AM
Replies: 3
Views: 664
Posted By Megahurtz
If its changing gears in automatic mode, that's...

If its changing gears in automatic mode, that's normal as mentioned. It's not a DCT so there will be a delay when it has to change from 8th-10th gear to 3rd gear.

Put it in manual mode, hold the...
Forum: ZL1 Discussions 09-01-2025, 03:50 PM
Replies: 11
Views: 1,259
Posted By Megahurtz
Drag radials will help and be a compromise for...

Drag radials will help and be a compromise for traction vs stability. But a 15 inch conversion will get you the most traction.....but the car will handle like garbage. So if you're only interested in...
Forum: ZL1 Discussions 08-04-2025, 02:09 PM
Replies: 23
Views: 2,813
Posted By Megahurtz
It still has the DOD lifters even though some LT4...

It still has the DOD lifters even though some LT4 vehicles don't have the featured enabled.
Forum: ZL1 Discussions 07-26-2025, 10:04 AM
Replies: 55
Views: 2,435
Posted By Megahurtz
Correct, but its not harmful. It just wont ever...

Correct, but its not harmful. It just wont ever go into 1st gear. With the 10 speeds, you can do second gear start, but you actually tune 1st gear out completely so the car will never shift into 1st....
Forum: ZL1 Discussions 07-25-2025, 04:18 PM
Replies: 55
Views: 2,435
Posted By Megahurtz
Pretty sure King is correct The 10 Speeds...

Pretty sure King is correct

The 10 Speeds essentially you just lock out 1st gear permanently so it never shifts into 1st. The 8 speeds you can still use 1st but you can shift into second and...
Forum: ZL1 Discussions 07-23-2025, 08:18 AM
Replies: 55
Views: 2,435
Posted By Megahurtz
If you're on pump gas, pulleys are just going to...

If you're on pump gas, pulleys are just going to make the car hit hard when you punch it and then the power will quickly fall off up top. Once you're heat soaked you will be slower than stock.

If...
Forum: ZL1 Discussions 07-21-2025, 01:48 PM
Replies: 30
Views: 3,425
Posted By Megahurtz
You can send a sample of the oil to be analyzed...

You can send a sample of the oil to be analyzed and see what type of metal is in the oil. This may help shed some light on what is wearing abnormally.

It won't hurt to change the oil and drive it...
Forum: ZL1 Discussions 07-21-2025, 08:56 AM
Replies: 42
Views: 3,264
Posted By Megahurtz
For your normal bolt on street car, uncoated...

For your normal bolt on street car, uncoated QUALITY stainless steel headers is a non issue. If you start making 900+ wheel HP and race the car at the track...you want to start considering having...
Forum: ZL1 Discussions 07-21-2025, 08:52 AM
Replies: 30
Views: 3,425
Posted By Megahurtz
That isn't normal for an LT4 engine with 25K...

That isn't normal for an LT4 engine with 25K miles.
Was the car bone stock or modified?
Any maintenance records?
Forum: ZL1 Discussions 07-10-2025, 08:40 AM
Replies: 72
Views: 6,013
Posted By Megahurtz
I think this could be true on the dyno with the...

I think this could be true on the dyno with the hood opened...likely how it will or was tested. But if you look at where it can pull in fresh air, that path is smaller than the RFBG and I think this...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 06:25 PM.

Contact Us - CAMARO6 - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.