Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Phastek Performance


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.09 seconds. Search: Posts Made By: Joshinator99
Forum: Forced Induction Discussions Today, 09:07 AM
Replies: 9
Views: 201
Posted By Joshinator99
Thanks King :happy0180:

Thanks King :happy0180:
Forum: Forced Induction Discussions Yesterday, 06:45 PM
Replies: 9
Views: 201
Posted By Joshinator99
I went down this road with my old 2.9 Whipple…if...

I went down this road with my old 2.9 Whipple…if your blower is out of steam it’s time for a better blower that will operate at your desired airflow level in a much better efficiency island on the...
Forum: ZL1 Discussions 05-19-2024, 07:58 PM
Replies: 7
Views: 410
Posted By Joshinator99
Well I’m not sure about “bigger brain” but I’ll...

Well I’m not sure about “bigger brain” but I’ll chime in… :smiling1: :bonk:

It’s nice to see stuff on the iDash but datalogging on HP Tuners is where it’s at. Since the AEM 30-0334 makes it SO...
Forum: ZL1 Discussions 05-18-2024, 02:17 PM
Replies: 14
Views: 606
Posted By Joshinator99
Yeah you were right there so no surprise.

Yeah you were right there so no surprise.
Forum: ZL1 Discussions 05-18-2024, 02:16 PM
Replies: 14
Views: 606
Posted By Joshinator99
1000 WHP is just under 1200 crank HP. You’re...

1000 WHP is just under 1200 crank HP. You’re pretty much asking for double what GM intended. So if you’re pulling it apart to do studs, thrust bearing, etc and you’re dropping 1K WHP money, then...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-18-2024, 12:02 PM
Replies: 1
Views: 232
Posted By Joshinator99
Yes and yes. Upgrading to an LT4 in tank plus...

Yes and yes. Upgrading to an LT4 in tank plus JMS voltage booster is pretty much the bare minimum to run a blower and any E at all.
Forum: ZL1 Discussions 05-18-2024, 08:04 AM
Replies: 14
Views: 606
Posted By Joshinator99
LT4 rods have been pulled at that level and were...

LT4 rods have been pulled at that level and were bending. Aftermarket options are superior… if you’re going to pull it apart for a proper thrust bearing and main studs, it’s insane to reuse pistons...
Forum: ZL1 Discussions 05-17-2024, 09:36 PM
Replies: 14
Views: 606
Posted By Joshinator99
FYI at 1K WHP the LT4 short block is on borrowed...

FYI at 1K WHP the LT4 short block is on borrowed time…. Crank is fine but the LT4 “forged” pistons & rods should be upgraded.
Forum: Forced Induction Discussions 05-16-2024, 03:25 PM
Replies: 23
Views: 1,199
Posted By Joshinator99
Looking forward to seeing your results with the...

Looking forward to seeing your results with the 555R2. If they really do hook well then I’d go that route next time instead of the R888R.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-15-2024, 08:22 PM
Replies: 6
Views: 459
Posted By Joshinator99
Yep, I tried the Magnaflow axle back 6-7 years...

Yep, I tried the Magnaflow axle back 6-7 years ago…terrible drone lol. Went with the AWE Touring catback and it’s fantastic. Zero drone and best tips out there.
Forum: Dragstrip and Launching Discussion 05-15-2024, 04:50 PM
Replies: 9
Views: 325
Posted By Joshinator99
Make sure the skinnies are bias ply too then. Do...

Make sure the skinnies are bias ply too then. Do not mismatch them. :smm7:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-14-2024, 09:11 AM
Replies: 25
Views: 973
Posted By Joshinator99
Total airflow > IAT1 temps Keep in mind your...

Total airflow > IAT1 temps

Keep in mind your IAT1 temp is PRE-intercooler. The fastest PD blower Gen6 Camaro (ZL1Atlanta) has a wide open air filter in the engine bay with no shield or baffle...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-14-2024, 08:14 AM
Replies: 16
Views: 796
Posted By Joshinator99
Uh, that’s not true. Add more power my friend...

Uh, that’s not true. Add more power my friend lol…
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-14-2024, 08:12 AM
Replies: 25
Views: 973
Posted By Joshinator99
:happy0180:

:happy0180:
Forum: ZL1 Discussions 05-13-2024, 09:15 PM
Replies: 128
Views: 10,065
Posted By Joshinator99
Correct. It’s an either/or scenario...

Correct. It’s an either/or scenario unfortunately.

I got a second look from the time slip guy my last run of the year when I broke 150 MPH… but it was literally the end of the day on the last...
Forum: ZL1 Discussions 05-13-2024, 08:13 PM
Replies: 128
Views: 10,065
Posted By Joshinator99
Yeah I’m right there with you…

Yeah I’m right there with you…
Forum: ZL1 Discussions 05-13-2024, 08:10 PM
Replies: 14
Views: 704
Posted By Joshinator99
Yep, I had a blower belt break too which makes an...

Yep, I had a blower belt break too which makes an absolute mess. The billet thermostat housing solves the problem forever. But this “guard” isn’t a bad idea either but not as foolproof as the...
Forum: Forced Induction Discussions 05-13-2024, 05:44 PM
Replies: 12
Views: 479
Posted By Joshinator99
Looks fine. Tune is the key. Keep the boost...

Looks fine. Tune is the key. Keep the boost reasonable and run as much E as your fuel system will let you run. Port injection is a better move than LT4 HPFP and injectors…
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 05-13-2024, 05:40 PM
Replies: 103
Views: 27,826
Posted By Joshinator99
To the best of my knowledge, that’s a big fat...

To the best of my knowledge, that’s a big fat “no” unfortunately. I keep peeking on the couple of random Banks threads on this board and have not seen anything new. I like the Banks for general...
Forum: ZL1 Discussions 05-13-2024, 05:35 PM
Replies: 128
Views: 10,065
Posted By Joshinator99
And a full cage…

And a full cage…
Forum: ZL1 Discussions 05-13-2024, 11:29 AM
Replies: 128
Views: 10,065
Posted By Joshinator99
Great run. Surprised they didn’t let you run...

Great run. Surprised they didn’t let you run some 1/8 mile hits at least… throwing you off for being 1 mph over is a jerk move.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-13-2024, 09:02 AM
Replies: 25
Views: 973
Posted By Joshinator99
Negative. Worth virtually nothing. Listen to...

Negative. Worth virtually nothing. Listen to Megahurtz, he know what he’s talking about.
Forum: ZL1 Discussions 05-13-2024, 07:32 AM
Replies: 21
Views: 805
Posted By Joshinator99
Haha nice! :thumbup: I got sick of the ice...

Haha nice! :thumbup:

I got sick of the ice tank and it’s near 100 pound weight penalty which really isn’t needed when running E, so I decided to ditch it and run as much heat exchanger as I...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-12-2024, 09:14 PM
Replies: 50
Views: 6,570
Posted By Joshinator99
Thanks! I feel the same way, Driven really don’t...

Thanks! I feel the same way, Driven really don’t seem to be chasing the standard “OEM maintenance/warranty” guys and agree that the standard GM-recommended oils are perfectly fine as well (which I...
Forum: ZL1 Discussions 05-12-2024, 07:20 PM
Replies: 21
Views: 805
Posted By Joshinator99
Just installed the AFCO triple HX setup this...

Just installed the AFCO triple HX setup this weekend myself as well, so looking forward to putting them through the paces. :thumbup:
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-12-2024, 03:54 PM
Replies: 50
Views: 6,570
Posted By Joshinator99
Great thing about America is that if you don’t...

Great thing about America is that if you don’t like or agree with them, you’re free to buy whatever oil you’d like. :)

Meanwhile my engine makes 1059 WHP on a stock LT1 crank running that oil so...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-11-2024, 07:26 PM
Replies: 16
Views: 796
Posted By Joshinator99
Wow, guess it’s just a bad tire. That should do...

Wow, guess it’s just a bad tire. That should do that all day long normally.
Forum: Tuning / Diagnostics 05-11-2024, 11:49 AM
Replies: 15
Views: 358
Posted By Joshinator99
Nice, glad you got it sorted. :happy0180:

Nice, glad you got it sorted. :happy0180:
Forum: Member Car Journals 05-11-2024, 10:09 AM
Replies: 2
Views: 250
Posted By Joshinator99
Looking good, Tony!

Looking good, Tony!
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-10-2024, 08:40 PM
Replies: 24
Views: 4,458
Posted By Joshinator99
I think it would destroy your MAF scaling even...

I think it would destroy your MAF scaling even worse than the bellmouth does… the air filter helps to straighten the airflow across the sensor, giving you repeatable results. Even the bellmouth...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 09:24 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.