Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 15 1 234511 Last »
Showing results 1 to 30 of 440
Search took 0.03 seconds. Search: Posts Made By: 19Nasty1le
Forum: ZL1 Discussions 09-13-2025, 03:40 PM
Replies: 0
Views: 468
Posted By 19Nasty1le
Bad Isolator or Bearing?

Got this blower ported by Jokerz and it’s making this noise after about 1500KM the car is 900whp full bolt on / cam etc. I’m being told they think it’s the isolator but has anyone had similar sound...
Forum: ZL1 Discussions 09-11-2025, 07:00 PM
Replies: 6
Views: 717
Posted By 19Nasty1le
So I checked… I was looking at 43 because I saw...

So I checked… I was looking at 43 because I saw Exh Vlv lol 51 was missing so tossed a 15 in but now when I turn the car to ACC (to move valves before car starts) it sounds like this until I select...
Forum: ZL1 Discussions 09-08-2025, 04:05 PM
Replies: 6
Views: 717
Posted By 19Nasty1le
NPP won’t work?

Just swapped my Corsa Extreme+ system for the Corsa NPP axelback to quiet the car down a bit after mods but the valves are just staying wide open they don’t respond to any mode selection. Has anyone...
Forum: ZL1 Discussions 08-30-2025, 08:12 PM
Replies: 0
Views: 416
Posted By 19Nasty1le
Possible methanol leak?

I noticed this bubbling on my side skirt just above the PPF line and below the fender. The car is modified and the washer tank is now used for meth holding and the pump is mounted behind the fender...
Forum: ZL1 Discussions 07-25-2025, 09:56 PM
Replies: 7
Views: 506
Posted By 19Nasty1le
Yeah just realized that about the SC system vs...

Yeah just realized that about the SC system vs the engine system. Wonder if there’s a trick to getting the air out of the Eng side without vacuum fill? I wondered about the LS3 stat, kinda wasted...
Forum: ZL1 Discussions 07-25-2025, 07:27 PM
Replies: 7
Views: 506
Posted By 19Nasty1le
Thermostat Cracked?

I’ve been smelling coolant after my built and finally noticed just under the little tube at the top of the thermostat there’s a small line of coolant. So I’ve looked into the DMS Billet Housing but...
Forum: ZL1 Discussions 07-23-2025, 05:41 PM
Replies: 7
Views: 431
Posted By 19Nasty1le
I got my elbow off but seems like I need the belt...

I got my elbow off but seems like I need the belt off just to get to the sensor and then gotta try and get to the connector after lol
Forum: ZL1 Discussions 07-22-2025, 07:23 PM
Replies: 7
Views: 431
Posted By 19Nasty1le
I just grabbed a sensor too but I’ll try cleaning...

I just grabbed a sensor too but I’ll try cleaning this connector first, grabbed a can of compressed air as I don’t have anything else lol. Did you just have to remove the intake elbow to access or or...
Forum: ZL1 Discussions 07-21-2025, 08:10 PM
Replies: 7
Views: 431
Posted By 19Nasty1le
Did you get to that from above or below? The...

Did you get to that from above or below? The connector on the bottom right side(if looking at engine from front) red tab on it and it sits vertical?
Forum: ZL1 Discussions 07-21-2025, 05:35 PM
Replies: 7
Views: 431
Posted By 19Nasty1le
Camshaft Position Sensor

Has anyone replaced a camshaft position sensor? I keep getting P0340 after a recent stage 4 build so I’m going to try a new sensor. Just trying to see if it’s an easy replacement that I’ll be able to...
Forum: ZL1 Discussions 07-21-2025, 04:38 PM
Replies: 42
Views: 3,264
Posted By 19Nasty1le
I have the Kooks 2” CSP headers and had them...

I have the Kooks 2” CSP headers and had them coated at a place near me that does aviation coating for those type engines (they coated the inside and out) and for a 900whp street car they still get...
Forum: ZL1 Discussions 07-13-2025, 12:36 PM
Replies: 0
Views: 167
Posted By 19Nasty1le
P0340 / P3 Gauge Lambda Readings

I just got my car back from a build and they installed a P3 gauge and set the AN.1 to be reading in Lambda, but it’s reading like 1.500 at idle and when cruising it’s constantly jumping all around,...
Forum: ZL1 Discussions 07-12-2025, 03:48 PM
Replies: 3
Views: 511
Posted By 19Nasty1le
Awesome thank you! Do you do the one barbed side...

Awesome thank you! Do you do the one barbed side against the rock guard side then?
Forum: ZL1 Discussions 07-10-2025, 06:46 PM
Replies: 3
Views: 511
Posted By 19Nasty1le
ZL1 Addons Rock Guard Clip

So my car was recently in the shop for upgrades and when I was detailing it after it came back I noticed they’ve lost the lower front clip for the rock guard on passenger side to help hold it to the...
Forum: ZL1 Discussions 07-01-2025, 05:09 PM
Replies: 20
Views: 945
Posted By 19Nasty1le
You gained 80whp between a Jokerz port and Kong?

You gained 80whp between a Jokerz port and Kong?
Forum: ZL1 Discussions 06-30-2025, 11:36 PM
Replies: 20
Views: 945
Posted By 19Nasty1le
Here’s the dyno sheet, doesn’t show boost but was...

Here’s the dyno sheet, doesn’t show boost but was told it’s 15psi. I’m happy with the results, I was aiming for around 900whp. He’s a great tuner!
Stock Baseline
Pump
Pump / Meth
E55 / Meth
Forum: ZL1 Discussions 06-30-2025, 06:01 PM
Replies: 20
Views: 945
Posted By 19Nasty1le
Stock size 2.5” upper and 9.65” lower

Stock size 2.5” upper and 9.65” lower
Forum: ZL1 Discussions 06-30-2025, 06:00 PM
Replies: 20
Views: 945
Posted By 19Nasty1le
My lower is a 9.65 should be a 20% overdrive I...

My lower is a 9.65 should be a 20% overdrive I think right? I was told to avoid the smaller upper for belt slip purposes.
Forum: ZL1 Discussions 06-29-2025, 02:25 PM
Replies: 20
Views: 945
Posted By 19Nasty1le
How much boost??

Just curious here, just had my car finished and I have a Jokerz Race Port with 2.5 / 9.65 pulley combo 2” Kooks etc and it only made 15psi. Is this normal? Most the similar builds I see online are...
Forum: ZL1 Discussions 05-09-2025, 08:43 PM
Replies: 28
Views: 1,957
Posted By 19Nasty1le
Once I get them on I’ll post a picture! I’m sure...

Once I get them on I’ll post a picture! I’m sure others might have pics of it as well seems to be a popular choice.
Forum: ZL1 Discussions 05-07-2025, 09:01 PM
Replies: 28
Views: 1,957
Posted By 19Nasty1le
Going to give the 555R2 Rears / 555G2 fronts a...

Going to give the 555R2 Rears / 555G2 fronts a try. Went with a 345/30/19 and 305/30/19, debated 315/30/19 front but decided meh.
Forum: ZL1 Discussions 05-05-2025, 08:08 PM
Replies: 28
Views: 1,957
Posted By 19Nasty1le
I wonder if the Toyo R might be a good option...

I wonder if the Toyo R might be a good option then for you, it’s 40tw so similar to the ET Street R just a couple grooves
Forum: ZL1 Discussions 05-04-2025, 07:27 PM
Replies: 28
Views: 1,957
Posted By 19Nasty1le
How are they on the highway? I’ve heard a lot of...

How are they on the highway? I’ve heard a lot of issues with the MT swaying at higher speeds because of the softer sidewall, same comments for the 555R2 but not as bad, and the R888r seem to be the...
Forum: ZL1 Discussions 05-04-2025, 07:18 PM
Replies: 28
Views: 1,957
Posted By 19Nasty1le
Yeah it’s never going to see a drag strip so...

Yeah it’s never going to see a drag strip so that’s why I was looking into which of the more streetable tires will work the “Best” it’ll be rolls on the highway if anything.
Forum: ZL1 Discussions 05-04-2025, 06:04 PM
Replies: 28
Views: 1,957
Posted By 19Nasty1le
850-900whp Street Tires

I know this has been beaten over and over but I’m hoping someone has got some real world experience with these tires to chime in and help me out. Car is getting built soon and should be around the...
Forum: ZL1 Discussions 12-06-2024, 10:24 PM
Replies: 9
Views: 1,240
Posted By 19Nasty1le
Yeah it’s just a fun weekend car not a daily by...

Yeah it’s just a fun weekend car not a daily by any means
Forum: ZL1 Discussions 12-06-2024, 07:29 PM
Replies: 9
Views: 1,240
Posted By 19Nasty1le
Yeah a buddy runs them on his 1200whp C7 and said...

Yeah a buddy runs them on his 1200whp C7 and said he loves them that he won’t run another tire… so was curious
Forum: ZL1 Discussions 12-06-2024, 06:19 PM
Replies: 9
Views: 1,240
Posted By 19Nasty1le
New Toyo R vs R888r

Just looking for some inputs if anyone has tried both or either tire on a similar setup. I know the new Toyo R is supposed to be a better “RR” and it was suggested by a friend to run on the car. I...
Forum: ZL1 Discussions 11-19-2024, 05:15 PM
Replies: 6
Views: 1,866
Posted By 19Nasty1le
Katech A7502 vs A7503 for ZL1

I came across this video and I’m wondering if it’s worth getting the L86 version of the pump for the increased pressure since the car will be getting tuned and stuff anyways. Has anyone done this...
Forum: ZL1 Discussions 11-15-2024, 06:37 PM
Replies: 20
Views: 1,523
Posted By 19Nasty1le
I’ll be happy with 900whp, currently looking into...

I’ll be happy with 900whp, currently looking into the Katech Oil Pump, C5-R timing chain and LME chain guide while I’m down in that area doing stuff. Think I’ll wait on porting the heads for now
Showing results 1 to 30 of 440
Page 1 of 15 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 03:19 AM.

Contact Us - CAMARO6 - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.