Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Bigwormgraphix


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.09 seconds. Search: Posts Made By: KingLT1
Forum: ZL1 Discussions Today, 09:29 AM
Replies: 23
Views: 516
Posted By KingLT1
Methanol injection and spin the blower harder...

Methanol injection and spin the blower harder would be the cheapest route. It's how you get more out of a blower that is tapped out otherwise. Just use it for cooling and not supplemental fuel and...
Forum: Forced Induction Discussions 06-05-2024, 10:11 AM
Replies: 13
Views: 346
Posted By KingLT1
I am pretty sure this is why guys have also...

I am pretty sure this is why guys have also snapped the pulley shaft off the end of the Whipple supercharger. If you don't have the slide tensioner washer on the back side oriented in the correct...
Forum: ZL1 Discussions 06-04-2024, 05:21 PM
Replies: 21
Views: 997
Posted By KingLT1
C8 looks great! Have fun with the new ride....

C8 looks great! Have fun with the new ride. :respekt:
Forum: ZL1 Discussions 06-04-2024, 08:17 AM
Replies: 59
Views: 2,127
Posted By KingLT1
Correct, but the main point I was attempting to...

Correct, but the main point I was attempting to make is the fueling upgrades are going to cost more than what I believe the OP realizes regardless which direction he goes.
Forum: ZL1 Discussions 06-03-2024, 08:23 AM
Replies: 59
Views: 2,127
Posted By KingLT1
Fueling is expensive to upgrade, especially if...

Fueling is expensive to upgrade, especially if you run E which I recommend. In a manual car +30 injectors and a low side will support 800whp on E60. However, Port Injection offers the best ROI. I...
Forum: Dragstrip and Launching Discussion 06-03-2024, 08:07 AM
Replies: 4
Views: 327
Posted By KingLT1
28" tire, driveshaft, axles.

28" tire, driveshaft, axles.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-01-2024, 06:52 AM
Replies: 21
Views: 9,557
Posted By KingLT1
This feature has been removed in HPtuners. And...

This feature has been removed in HPtuners. And disabling cat warmup quiets down the cold start for anybody that wants to know. You would have to find a pre 4.4.12 software version in order to still...
Forum: Forced Induction Discussions 06-01-2024, 06:43 AM
Replies: 9
Views: 464
Posted By KingLT1
I assume it would work "better" on the Hellcat...

I assume it would work "better" on the Hellcat because they have a much larger supercharger to start with. I think you would need to X port the stock blower and at that point I would probably just...
Forum: Forced Induction Discussions 05-31-2024, 10:37 AM
Replies: 12
Views: 558
Posted By KingLT1
Just depends on setup, use, and goals. Some out...

Just depends on setup, use, and goals. Some out there prefer to make as much power as they can with motor and use the least amount of boost to get to end goal.

Stock cubes imo is a good choice...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-30-2024, 04:21 PM
Replies: 64
Views: 3,204
Posted By KingLT1
NA cars don't need to worry about MAT. ...

NA cars don't need to worry about MAT.



That is correct hence why I said to compare WOT vs Key on map reading. That will let you know for sure if there is a restriction or the air is simply...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-30-2024, 08:00 AM
Replies: 64
Views: 3,204
Posted By KingLT1
You need to check your key on(engine not running)...

You need to check your key on(engine not running) map kpa then compare it to your WOT map kpa. If they match, then there is no restriction. I was assuming based on you being in Michigan, but I should...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-29-2024, 07:52 AM
Replies: 8
Views: 442
Posted By KingLT1
:nod:

:nod:
Forum: Forced Induction Discussions 05-25-2024, 08:46 AM
Replies: 7
Views: 484
Posted By KingLT1
Yes +65 were discontinued. I would say...

Yes +65 were discontinued.

I would say 15whp difference on most builds under 1000whp going from E50 to 80.
Forum: Forced Induction Discussions 05-24-2024, 08:00 AM
Replies: 7
Views: 484
Posted By KingLT1
I would probably go with the +50 and LPE HPFP. If...

I would probably go with the +50 and LPE HPFP. If you do the +30, then they run out of headroom before the LPE HPFP, If you do the +65, the LPE HPFP runs out before the 65's. Hence why LPE probably...
Forum: Forced Induction Discussions 05-21-2024, 07:27 PM
Replies: 15
Views: 698
Posted By KingLT1
agree!!

agree!!
Forum: Forced Induction Discussions 05-21-2024, 10:10 AM
Replies: 28
Views: 1,555
Posted By KingLT1
23 makes a difference in traction with the 555r2....

23 makes a difference in traction with the 555r2. My best no prep 0-60 is 3.0 (no roll out) at 23psi. Up at 28psi, 3.3 is the best I can get. And they hook better from a second gear roll too. I do...
Forum: Forced Induction Discussions 05-21-2024, 10:07 AM
Replies: 15
Views: 698
Posted By KingLT1
FWIW GM setup the LT1 and LT4's along with many...

FWIW GM setup the LT1 and LT4's along with many other ICE engines to live off the knock sensors. They are literally way over timed from the factory. In the very most optimal conditions you may see...
Forum: Forced Induction Discussions 05-21-2024, 08:04 AM
Replies: 10
Views: 366
Posted By KingLT1
Yeah so you will need +50 injectors, a bigger...

Yeah so you will need +50 injectors, a bigger HPFP, along with a better low side.
Forum: Forced Induction Discussions 05-21-2024, 07:55 AM
Replies: 15
Views: 698
Posted By KingLT1
Centri's are different my friend. The Air to Air...

Centri's are different my friend. The Air to Air intercoolers are not as effective at keeping temps from increasing during a pull but they are better at cooling down after a pull. Hence why many use...
Forum: Forced Induction Discussions 05-21-2024, 07:38 AM
Replies: 10
Views: 366
Posted By KingLT1
If your cam doesn't have a bigger fuel lobe, then...

If your cam doesn't have a bigger fuel lobe, then Port injection and a low side upgrade. If it does then you could do bigger injectors(+50's,LPE HPFP, and low side). This is all based on continuing...
Forum: Forced Induction Discussions 05-20-2024, 08:46 AM
Replies: 15
Views: 698
Posted By KingLT1
What are the temps? Is it actually showing knock...

What are the temps? Is it actually showing knock in the log or just pulling timing due to reaching a specific IAT temperature?
Forum: ZL1 Discussions 05-19-2024, 04:15 PM
Replies: 24
Views: 1,108
Posted By KingLT1
Switch to taller tires?

Switch to taller tires?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-18-2024, 08:53 AM
Replies: 47
Views: 7,742
Posted By KingLT1
sounds good!

sounds good!
Forum: Autos For Sale / Wanted 05-17-2024, 08:02 AM
Replies: 5
Views: 1,019
Posted By KingLT1
That sold for a good price!

That sold for a good price!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-16-2024, 04:09 PM
Replies: 7
Views: 714
Posted By KingLT1
^Agree with both posts.

^Agree with both posts.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-14-2024, 08:04 AM
Replies: 25
Views: 1,235
Posted By KingLT1
Are we really arguing power gains from a filter...

Are we really arguing power gains from a filter and muffler swap in 2024? If you want to do it, then do it...but it's not gaining you shit for power. These cars were optimized a lot more than...
Forum: Forced Induction Discussions 05-14-2024, 07:56 AM
Replies: 12
Views: 591
Posted By KingLT1
Imo it's counterintuitive to install a cam and...

Imo it's counterintuitive to install a cam and not upgrade the rods and pistons. The engine is likely going to come out anyway and be torn down to the short block. Otherwise, the potential of the cam...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-12-2024, 09:57 AM
Replies: 16
Views: 1,018
Posted By KingLT1
^Agree...that is simply a defective tire.

^Agree...that is simply a defective tire.
Forum: Tuning / Diagnostics 05-11-2024, 09:48 AM
Replies: 15
Views: 474
Posted By KingLT1
Pretty sure you need the latest beta.

Pretty sure you need the latest beta.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-09-2024, 09:09 AM
Replies: 58
Views: 5,156
Posted By KingLT1
Getting better...It still seems lazy out of the...

Getting better...It still seems lazy out of the hole like there is a delay on the initial hit of the throttle. You should be able to 1.6 60ft fairly easy. Next time out try brake stalling it as high...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 06:00 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.