Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Engine | Drivetrain | Powertrain Technical Discussions > V8 LT1 Engine, Exhaust, and Bolt-Ons


Phastek Performance


Post Reply
 
Thread Tools
Old 05-10-2016, 04:51 PM   #295
TRich2SS
 
Drives: 2016 Camaro 2SS Summit White
Join Date: May 2016
Location: Maryland
Posts: 260
I purchased the intake over the weekend and installed. I drove a few hundred miles and I also notice the whistle. Like another poster said, I don't mind the sound and I actually think it sounds good personally. The only thing I am concerned about is that the intake doesn't fit into the air box straight on. I tried but was only successful in getting it in at an angle which leans towards the front of the car. It doesn't seem to cause any leaks and the rubber around the hole where the MAF tube meets the intake is tightly sealed. I am however concerned that I might have a mis-manufactured piece of tubing. It appears the rubber elbow connecting the MAF tube to the throttle body is too long. CAI, can you chime in on this please? Ill post a pic when I get home.
TRich2SS is offline   Reply With Quote
Old 05-10-2016, 04:52 PM   #296
Jeanius


 
Jeanius's Avatar
 
Drives: Blk/Blk 2018 Sierra SLT
Join Date: Dec 2006
Location: Golden State
Posts: 2,925
Quote:
Originally Posted by Sales @ CAI Inc View Post
Hello Forum members,

We appreciate your support!

This should help everyone understand the origin of the now infamous "whistle noise"

http://www.coldairinductions.com/press/why-does-my-camaro6-cold-Air-intake-whistle/
Thanks, can you please address the following?

Quote:
However im still curious as to why. This isn't my first intake I've ever done. I've installed intakes on other cars over the years, dual cold air intakes on my 350z and none were ever this anal about filter alignment. Correct me if I'm wrong but the filter is round cone type so essentially all sides are the same. The only part of the filter that's different is the seam where the element comes together. Does this seam, lining up with the MAF sensor angle help "block" some air going past the sensor to keep it from "seeing" too much air?
__________________
SOLD: 2SS LS3 M6 - MGW - Dynatech LT's HF Cats - Magnaflow Street CB - ADM Race CAI - Pedders Xa Coilovers - Pfadt Sways

TRADED: 2016 2SS M6
Jeanius is offline   Reply With Quote
Old 05-10-2016, 05:00 PM   #297
jamminj007
 
jamminj007's Avatar
 
Drives: 2016 Camaro Black 2SS, 69 Camaro
Join Date: Jan 2016
Location: Houston
Posts: 107
Quote:
Originally Posted by laynlo15 View Post
I guess I don't see a problem. I didn't unhook the battery when I installed mine and that probably set the code. The instructions said to do that. I've install a bunch cold airs on many a car and truck and never took the negative off. So, I think I probably caused the issue, so I went back as I said and pulled the maf unhooked the battery and no issues. Just do what the instructions say and you shouldn't have a problem. I think everyone is over reacting, especially if they whistle with the stock intake. Mine has never done that and I never heard it with the stock intake. So, just maybe its a GM issue, not CAI
I didn't unhook the battery cable and didn't get a light so that is a non-issue.
__________________
2 SS Murderd
69 Camaro Pro-Touring
jamminj007 is offline   Reply With Quote
Old 05-10-2016, 06:24 PM   #298
keon718nyc

 
Drives: Challenger SP Shaker/Arcadia Denali
Join Date: Jan 2016
Location: New York City
Posts: 1,928
Quote:
Originally Posted by chevyfan#1 View Post
No trolling here. What did they do wrong? Like they mentioned before if your not happy return it.
What did they do wrong.... What do i have to Bitch about.... Return it? Well for me its too late since the 6th of this month Amazon where i bought it from expired. I messaged CAI and they said i would have to return it to the seller which it is too late right now since i been waiting for a solution for a crap sounding whistle noise that CAI said they would come up with unless i read something wrong in one of the previous posts here in this thread. Ok so yea i can bitch and moan and yes i have done business with them in the past with no negative experiences but shit happens and there is a larger percent of people then originally thought out to be with this whistle noise issue. Its not so simple to just replace the stock intake back and resell mine for anything near what i paid so i stand waiting for that solution like some others here.
keon718nyc is offline   Reply With Quote
Old 05-10-2016, 06:54 PM   #299
Ian SS

 
Ian SS's Avatar
 
Drives: 2016 1SS, 2017 JKU Wrangler
Join Date: Mar 2016
Location: San Diego
Posts: 876
Quote:
Originally Posted by Sales @ CAI Inc View Post
Hello Forum members,

We appreciate your support!

This should help everyone understand the origin of the now infamous "whistle noise"

http://www.coldairinductions.com/press/why-does-my-camaro6-cold-Air-intake-whistle/

Quote:
Originally Posted by slo_1ss View Post
I get the whistle under moderate throttle and I have the msd intake manifold
^
__________________
SLO 1SS - sold
1SS MRC NPP 6MT

2018 Ram Rebel 4x4 5.7
Ian SS is offline   Reply With Quote
Old 05-10-2016, 07:42 PM   #300
Algeron

 
Algeron's Avatar
 
Drives: 2023 ZL1 Convertible, 1998 Z28
Join Date: Jan 2013
Location: Charleston, SC
Posts: 915
Brief update

I installed my intake over lunch today. Being slightly lazy, I did not remove the negative cable from the battery. I was able to install the intake in under 30 min, and everything fit perfectly. I then drove to pick my kids up from school and to Best Buy. However, due to locations, I never got over 50 MPH, and I was not able to get on the gas. So far, no whistles and no codes.

As my wife received her college acceptance letter today (it is never too late), we went to dinner to celebrate. Again, under 50, and no issues. After dinner, we decided to take the long way home with the top down (side note - first time she has been in the car since I bought it). Once I got on the interstate, punched it. She sounded great, and still no codes or sounds. Once we got back to the main roads, I was playing with the throttle some, and I was able to get a very slight whistle that lasted less than half a second if I would punch it and jump right back off the gas.

As I mentioned this was very slight. If it was not for this thread, I would just take it as sounds from the unrestricted air flow due to the new intake. I will take it for a longer drive tomorrow evening and see if anything changes.


__________________
2023 Rapid Blue ZL1 Convertible
Algeron is offline   Reply With Quote
Old 05-10-2016, 08:26 PM   #301
AdmAnt13
 
AdmAnt13's Avatar
 
Drives: '16 Red Hot 2SS M6 NPP
Join Date: Apr 2016
Location: The Beach, NC
Posts: 603
Quote:
Originally Posted by keon718nyc View Post
What did they do wrong.... What do i have to Bitch about.... Return it? Well for me its too late since the 6th of this month Amazon where i bought it from expired. I messaged CAI and they said i would have to return it to the seller which it is too late right now since i been waiting for a solution for a crap sounding whistle noise that CAI said they would come up with unless i read something wrong in one of the previous posts here in this thread. Ok so yea i can bitch and moan and yes i have done business with them in the past with no negative experiences but shit happens and there is a larger percent of people then originally thought out to be with this whistle noise issue. Its not so simple to just replace the stock intake back and resell mine for anything near what i paid so i stand waiting for that solution like some others here.
To be honest, if I was in your position I would feel the same exact way. Demand quality from quality vendors. Don't let anyone tell you otherwise. It's very easy for people unaffected to say stop complaining.
Btw, I'm unaffected as I did not buy CAI.
__________________

'16 2SS, M6, Borla Atak
AdmAnt13 is offline   Reply With Quote
Old 05-11-2016, 06:43 AM   #302
laynlo15
 
Drives: 2022 Lt1 A10
Join Date: Nov 2015
Location: clark, mo
Posts: 8,882
I accept their explanation although I don't hear it with mine
laynlo15 is offline   Reply With Quote
Old 05-11-2016, 08:28 AM   #303
Atra
 
Drives: 16' 1SS M6
Join Date: Oct 2015
Location: GA
Posts: 566
Thank you CAI for making the blog and video for us. That is exactly the noise I hear only mine is louder. Do you guys think Chevy will even bother addressing something like this? It's kind of absurd : /. The guy with the MSD manifold getting the whistle as well. What's that about?
__________________
Nightfall Grey 1SS 56F Black Bowties
Atra is offline   Reply With Quote
Old 05-11-2016, 08:49 AM   #304
6spdhyperblue


 
Drives: 2SS 1LE
Join Date: Aug 2013
Location: US
Posts: 3,786
I don't see how Chevy has anything to do with this.
6spdhyperblue is offline   Reply With Quote
Old 05-11-2016, 09:13 AM   #305
Atra
 
Drives: 16' 1SS M6
Join Date: Oct 2015
Location: GA
Posts: 566
Quote:
Originally Posted by Nicul15 View Post
I don't see how Chevy has anything to do with this.
They made the f***ing manifold? They have to know that people buying a car for enthusiasts is going to get this mod...When your name is on the product..you have something to do with it.
__________________
Nightfall Grey 1SS 56F Black Bowties
Atra is offline   Reply With Quote
Old 05-11-2016, 09:16 AM   #306
Pckrfan795
 
Pckrfan795's Avatar
 
Drives: 2021 Shadow Grey ZL1M6
Join Date: May 2012
Location: Katy, TX
Posts: 384
Do the vettes have this issue? I'm pretty sure they have the same engine and intake

Sent from my SM-G930V using Tapatalk
__________________
2021 ZL1M6, Shadow Grey
Pckrfan795 is offline   Reply With Quote
Old 05-11-2016, 09:22 AM   #307
vtirocz


 
vtirocz's Avatar
 
Drives: 2017 Camaro 1SS M6
Join Date: Apr 2015
Location: Indy
Posts: 2,460
Quote:
Originally Posted by Atra View Post
They made the f***ing manifold? They have to know that people buying a car for enthusiasts is going to get this mod...When your name is on the product..you have something to do with it.
The stock setup does not have this issue. That's like blaming GM for an aftermarket exhaust not sounding good or being too loud.
vtirocz is offline   Reply With Quote
Old 05-11-2016, 09:26 AM   #308
BSX_Camaro
Unleash the Beast!
 
BSX_Camaro's Avatar
 
Drives: 2010 Camaro 2SS
Join Date: Jun 2010
Location: Indianapolis, IN
Posts: 521
Has anyone tried a ported throttle body? Does the whistle go away?
__________________
Summit White 2SS delivered 12-11-2015
BSX_Camaro is offline   Reply With Quote
 
Post Reply

Tags
6th gen camaro, 6th gen intake, camaro intake, camaro6, hyper blue


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:17 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.