[Mid_Life_Crisis]

Originally Posted by Gen6cyl

The factory camber spec on the Lt is .5 degrees negative camber, the ss negative .75. When I got my first alignment on of my front tires was .2 neg. My advice is to get 1.3 negative camber on front and .75 on rear. It will act like adding a bigger rear bar and it's cheap and easy. I would try 30 psi in the tires. The tires will work better in the dry the more the tread wears down but definitely replace with non run flats when the time comes.

I appreciate this info!

[BatMobileLT1]

Originally Posted by Mid_Life_Crisis

I am a bit bummed that my golf driver will not fit in the trunk no matter how I angle it.

This is even with back seat flipped down?

Mine fits fine but I always have rear seat down when loading golf clubs.

[Mid_Life_Crisis]

Originally Posted by BatMobileLT1

This is even with back seat flipped down?

Mine fits fine but I always have rear seat down when loading golf clubs.

I just put the bag with irons in the trunk diagonal and lay the woods in the back "seat" area. If I had a pull-cart, I'd be done. I don't want to mes with putting the seats down. Hell, with my old back, I cant even get to the release back there. Seriously I wish I had a rear seat delete setup.

[Alan47717]

Originally Posted by Mid_Life_Crisis

I am a bit bummed that my golf driver will not fit in the trunk no matter how I angle it.

Not even if you fold the rear seat down? I have had 8' pieces of baseboard molding in mine.

[Mid_Life_Crisis]

Originally Posted by Alan47717

Not even if you fold the rear seat down? I have had 8' pieces of baseboard molding in mine.

[BatMobileLT1]

Originally Posted by Mid_Life_Crisis

I just put the bag with irons in the trunk diagonal and lay the woods in the back "seat" area. If I had a pull-cart, I'd be done. I don't want to mes with putting the seats down. Hell, with my old back, I cant even get to the release back there. Seriously I wish I had a rear seat delete setup.

Okay - that makes more sense if you are trying to fit in with the seat up.
Otherwise I was trying to envision how long your driver had to be - something 8'+ per the other posts?