[SgtRick]

Originally Posted by Markoz28

The tires are ET street R. I had them at 22psi. Burnout for 6 seconds was a bit longer than I wanted but the line lock would not release. Would prefer about 3-4 seconds. Once I get everything fixed and sorted out I’m sticking with that psi unless the track dictates something else. First pass I felt no wiggle on the big end with that pressure and trap speed was on point. I’m pretty confident that the car will do a 140mph trap with good launch and everything holding together.

What 60 foot did you get?

[Markoz28]

Originally Posted by SgtRick

What 60 foot did you get?

First run was a 2.0 with some spinning but I babied it off the line. I wasn’t able to do a burnout bc I forgot how to use line lock. Got frustrated and just rolled to the beams. Left with little preload at 900rpm and 1/4 throttle the first 100ft then pinched it. Ran 11.1 at 137mph.

Second run I have no idea as it broke

[Markoz28]

Quick update. It was not the drive shaft.
Broke the right side axle.

[Joshinator99]

Originally Posted by Markoz28

Quick update. It was not the drive shaft.
Broke the right side axle.

Going with GForce Outlaws?

[Markoz28]

Originally Posted by Joshinator99

Going with GForce Outlaws?

Might lean toward the DSS axles. Gforce are a bit more.

[Flexhorn]

You don’t have to burnout for the whole 15 seconds line Lock is initiated. Just light em up a little it and let the timer run down.

[6spdhyperblue]

Agreed. When I see smoke I call it

[Markoz28]

Originally Posted by Flexhorn

You don’t have to burnout for the whole 15 seconds line Lock is initiated. Just light em up a little it and let the timer run down.

Lol! Yea 15seconds would be bad. My burnout was 6seconds bc I was trying to get line lock disengaged to roll forward but it wouldn’t. I much rather prefer a 3 second burnout.

[laynlo15]

I have the DSS and happy with them. You saved yourself a bunch of labor time but the axles are more then the DS.

[Markoz28]

Originally Posted by laynlo15

I have the DSS and happy with them. You saved yourself a bunch of labor time but the axles are more then the DS.

Yea the axles are 2x more than the DS. I just found out there is a 4 week build time. I have not taken the axle off so I’m still not clear on the damage. Was wondering if it was a fluke and the ZL1 axles are in fact strong but maybe I ended up with a dud? I don’t want to rush things but don’t want to be out of the game too long either.

[SienarSystems]

There’s a set of DSS for sale in the classifieds: https://www.camaro6.com/forums/showthread.php?t=571266

[Markoz28]

Originally Posted by SienarSystems

There’s a set of DSS for sale in the classifieds: https://www.camaro6.com/forums/showthread.php?t=571266

Unfortunately those were sold and they were SS axles so would not fit the ZL1.

[Markoz28]

So broke 4 teeth off the axle and blew out the bearings from the CV joint.

[laynlo15]

Whew, screwed that one didn't ya. Dam