|
|
#1 |
![]() |
Click or knock noise from steering column
This morning I had some lady run a red light and I had to white knuckle turn left, hard on brakes to avoid a collision and hard turn the other way to miss the car in the other lane. No question I was hanging on to the steering wheel for dear life...
Shortly afterwards as I sharply turning right into a parking lot I hear a click from the steering column. On way out I hear the same thing from column when turning sharply to the right. I am pretty sure its coming from steering wheel area/column and not the engine bay. I just went for a drive again and took it to a school parking lot. I can mostly reproduce it but at much lower speeds it sounds more like a knock. Sounds like I messed up the electronic steering stuff. Any ideas before I take it to dealer? |
|
|
|
|
|
#2 |
![]() ![]() Drives: 2017 ZL1 Join Date: Oct 2016
Location: Ny
Posts: 859
|
Its probably the sway bar end link bolts. Check them before going in
__________________
My Car Blog and mods. Previous Chevys: 2016 2ss, 2015 C7 z51, 2004 C5 Z06
|
|
|
|
|
|
#3 |
![]() Drives: 2016 2SS w/chrome blue stripes Join Date: Aug 2009
Location: Charleston, SC
Posts: 224
|
I had the same issue with crunching noises coming from the steering when doing 3-point turns in my driveway. It turned out that the steering gear had to be replaced, but that was after they replaced the transmission mount (visit 1), tightened/checked all steering linkage (visit 2) and replaced the tie-rod end links (visit 3). The steering gear was replaced on visit 4. Ridiculous service.
|
|
|
|
|
|
#4 |
![]() |
I looked underneath and didn't see anything obvious. With car running I can reproduce by just rocking steering back and forth. I'm attaching video. Have dealer appointment next week.
|
|
|
|
|
|
#5 | |
![]() Drives: 2017 Summit White Coupe Join Date: Apr 2017
Location: Florida
Posts: 46
|
Quote:
dave
__________________
17 Camaro LT V6
ZL1/1LE Conversion |
|
|
|
|
|
|
#6 | |
![]() ![]() ![]() ![]() Drives: Black 2017 Camaro SS 1LE Join Date: Dec 2016
Location: Virginia Beach
Posts: 1,319
|
Quote:
__________________
2017 1LE SS Black - Mods - Forged - lowered compression - BTR custom Cam - Whipple, 3.500 upper and 8.0 lower pulley, Roto-Fab, 1 7/8 Kooks headers, off road pipes, & 3" Kooks full exhaust. LT4 fuel system, with Alky single nozzle running 100% meth. (not installed yet) DSX Tuning flex fuel and DSX tuning Aux pump
|
|
|
|
|
|
|
#7 |
![]() Drives: 2017 Summit White Coupe Join Date: Apr 2017
Location: Florida
Posts: 46
|
Dealer kept it for 2 days, said the steering rods were loose and out of adjustment, coincidence it happened after steering recall was done ? He things so, said only was underneath to swap rack, this time entire column apart for both shafts to be properly adjusted/tightened. He said its common lately for this ending up to be the air bag, I wasn't so lucky.
Car fine since but took over 2 days to get it done. d-
__________________
17 Camaro LT V6
ZL1/1LE Conversion |
|
|
|
|
|
#8 |
![]() |
They warranty replaced my entire steering rack.
|
|
|
|
|
|
#9 |
![]() ![]() ![]() ![]() Drives: Black 2017 Camaro SS 1LE Join Date: Dec 2016
Location: Virginia Beach
Posts: 1,319
|
Ah.. I did find this other post where they said it was a loose bolt hitting the air bag. Going to check it out.
https://www.camaro6.com/forums/showt...light=steering
__________________
2017 1LE SS Black - Mods - Forged - lowered compression - BTR custom Cam - Whipple, 3.500 upper and 8.0 lower pulley, Roto-Fab, 1 7/8 Kooks headers, off road pipes, & 3" Kooks full exhaust. LT4 fuel system, with Alky single nozzle running 100% meth. (not installed yet) DSX Tuning flex fuel and DSX tuning Aux pump
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|