[Drnick]

Any suggestions about what car ramps work for the ZL1?, need about
5-6” lift to perform an oil change, but most of the ramps I’ve seen
Are not long enough, or high enough, and don’t clear the front splitter.

[dmcmahan60]

https://www.google.com/url?sa=t&rct=...5&opi=89978449

[TheDocKlopek]

I found another thread where someone recommended these ramps.

https://www.amazon.com/gp/product/B0...e?ie=UTF8&th=1

So far they have worked out great for the few oil changes I have done. The splitter does touch be just barely.

[WhiteMale]

No need for race ramps @ $469...lol


Basic rhino ramps and 18-24" length of a 2X10 will be all you need.

[Drnick]

Thx, I found a set from discount ramps, with the promo code
And shipping $123….52”x15” x8.25”

[ZPirate]

Two piece Race Ramps are the way to go. They aren't cheap, but you get what you pay for. I use mine to change the oil in all my vehicles.

[AZ_1LE]

Originally Posted by TheDocKlopek

I found another thread where someone recommended these ramps.

https://www.amazon.com/gp/product/B0...e?ie=UTF8&th=1

So far they have worked out great for the few oil changes I have done. The splitter does touch be just barely.

I have these and they're great. I use them with all of our cars, including our heavy as hell Mercedes GLS 550. But with my ZL1 1LE, the rubber air director veins underneath get smooshed against the ramps when you drive up to them so I use a 4' long piece of 1/4" plywood on both sides to help with that.

But once the car is up on them, it's super nice to remove the ramp sections to make moving around under it easier, and the height is great for things like oil changes.

[Camfab]

They also make a 72” long set that lifts your car 8” vs 10”. It’s slightly narrower however it’s two piece and should easily work with any Camaro without ever rubbing.

https://www.discountramps.com/rr-72-2/p/RR-72-2/

They offer an additional 15% off as well. Around $385 shipped

(Thanks Drnick for the site!)

[dreksnot]

I made me some handy dandy 12" wooden ramps with detachable stands when lumber would have been $25. 10x that now.

[LT4Greg]

I bought a set of Race Ramps from Summit Racing that I use for my ZL1. They are the extended versions though. They work just fine for me.

[Camfab]

Originally Posted by dreksnot

I made me some handy dandy 12" wooden ramps with detachable stands when lumber would have been $25. 10x that now.

It’s always cool to see people’s creative take on retail products. Nice job!

[ZPirate]

I purchased a set of Race Ramp extenders for my 67 inch two piece Race Ramps. Those work great for the ZL1 to reduce the angle to keep the lower spoiler fromrubbingat all.

[Cheese ZL1]

I have Race Ramps and love them! I also made some wooden stands if I need all4 wheels off the ground.

https://www.raceramps.com/ramps/combo/p/rr-80-10-2/