[stlwrx]

For anyone wondering, yes, 345/25zr20 z06 wheels will fit on the rear of my 2020 LT1 Camaro. My good does it look gorgeous. Weirdly tho for the front z06 wheels I’ll have to run a 5-10 mm spacer you clear the strut tower.

[Kerry]

really interested in traction from a dig with that tire. I almost went that exact way myself and still might. Looks killer!!

[arpad_m]

Originally Posted by stlwrx

For anyone wondering, yes, 345/25zr20 z06 wheels will fit on the rear of my 2020 LT1 Camaro. My good does it look gorgeous. Weirdly tho for the front z06 wheels I’ll have to run a 5-10 mm spacer you clear the strut tower.

Looks very good Did you relocate the main body harness? Unless its routing was changed for 2020, you have to be careful about the liner rubbing through. You also sacrificed quite a bit of sidewall, please post about the effect of this on ride quality, if any.

[jkmskfk]

Update us on the front, did you get spacer?? How about harness??

[stlwrx]

Originally Posted by jkmskfk

Update us on the front, did you get spacer?? How about harness??

I did not have to move anything in regards to a harness. I will be ordering 15mm spacers tomo AM for the front wheels.

[TheRealJA105]

Originally Posted by stlwrx

I did not have to move anything in regards to a harness. I will be ordering 15mm spacers tomo AM for the front wheels.

Did you check your inner fender clearance? You might not have an issue with the harness because the tires are shorter, but with that high offset from the vette wheels and wide 345s i can't believe you aren't rubbing on the inside.

[Markoz28]

Looks a little thin.