[glamcem]

I really considered them as well but after rubbing the rear tires slightly even on smaller 19x11" wheels, I am not sure. The rear offsets are maxed out at -1.6 (without losing toe) I might get some rear toe links in the future

[cdb95z28]

Originally Posted by glamcem

The rear offset is 26mm AFAIK.

The Z/28 rears are stamped 19x11.5J x IS32.25.

[glamcem]

Not sure what the IS number is for X25 had them on his Gen 5 1LE:

http://www.camaro5.com/forums/showthread.php?t=396587

F 19x11ET11 (25mm further out than 1LE wheels)
R 19x11.5ET26 (23mm further out than 1LE wheels)

[cdb95z28]

Originally Posted by glamcem

Not sure what the IS number is for X25 had them on his Gen 5 1LE:

http://www.camaro5.com/forums/showthread.php?t=396587

I remember that thread, but even as X25 stated, it's stamped on the inside of the wheel. The above pic was taken by member V1LE8R on the "1LE Square Setup" thread

http://www.camaro6.com/forums/showpo...8&postcount=41

I've seen the remanufactured/salvage parts sites calling out 32.25mm also
http://www.hubcaphaven.com/p/16328/a...-22873227.html

https://detroitwheelandtire.com/hol-...gloss-a-r.html

6mm is not much as for the uncertainty of actual offset.

[TrackClub]

Originally Posted by glamcem

I really considered them as well but after rubbing the rear tires slightly even on smaller 19x11" wheels, I am not sure. The rear offsets are maxed out at -1.6 (without losing toe) I might get some rear toe links in the future

Cem, do u think the R would rub with 305s on?
The OP stated there was lots of clearance to strut.
These are a very top drawer wheels given Alcoa made them.

[glamcem]

Originally Posted by cdb95z28

I remember that thread, but even as X25 stated, it's stamped on the inside of the wheel. The above pic was taken by member V1LE8R on the "1LE Square Setup" thread

http://www.camaro6.com/forums/showpo...8&postcount=41

I've seen the remanufactured/salvage parts sites calling out 32.25mm also
http://www.hubcaphaven.com/p/16328/a...-22873227.html

https://detroitwheelandtire.com/hol-...gloss-a-r.html

6mm is not much as for the uncertainty of actual offset.

hmm it seems like you're right, I think he was using this thread as a reference : http://www.camaro5.com/forums/showthread.php?t=369676

Originally Posted by TrackClub

Cem, do u think the R would rub with 305s on?
The OP stated there was lots of clearance to strut.
These are a very top drawer wheels given Alcoa made them.

I think the inner clearance should be fine but there should be some sort of fender flare since it pokes out a lot. I wish there was a 10.5"/11.5" with correct offsets :/

[laynlo15]

Man those things hang out like crazy. Those will keep your paint guy busy for sure. Some will like and some won't. Me like um tucked.