You are browsing camaro6 
03-23-2026, 05:08 PM
|
#1 |
 Drives: Chevy Camaro ZL1 Join Date: Jul 2022
Location: Akron, Ohio
Posts: 11
|
Help pulling tr6060
Looking for help getting out my tr6060. I have pulled everything out but 2 bolts that I’m having a heckuva time getting out. The top three bolts are out, it’s just the middle bolt on either side that the tunnel is making very hard to put a socket on them at any angle…. Looking for help!! Need to get it pulled out so I can have it rebuilt!! Thanks in advance!
__________________
LME 416, CID heads, Too High port Plates, Kong Ported Maggie, Too High PSI lid, Fore triple pump system, FI interchiller, Reflex control, Big Gulp (modified), 112mm snout and NW throttle body, 2' headers, GESI 4.5" cats, Corsa 3' X-pipe and variable attack exhaust, VS5-RS 19" rims 305/345 cup2
|
|
|
|
03-23-2026, 07:28 PM
|
#2 |
    
Drives: 2017 2ss 6mt Join Date: Mar 2024
Location: dallas
Posts: 1,485
|
Are you pulling it with the bell housing?
Pull the shifter, then the driveshaft, then transmission crossmember, clutch line and electrical plugs, remove the transmission from the bell housing. Last edited by bishopts; 03-23-2026 at 08:00 PM. |
|
|
|
|
04-04-2026, 08:40 PM
|
#3 |
 Drives: 2024 Camaro 1SS Join Date: Mar 2024
Location: Minnesota
Posts: 434
|
OMG, my old M21 you pulled drive shaft, 2 bolts for shifter, 4 bolts on the tranny ears and then slid it out from underneath. Loved the good ole days
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
