|
|
#1 |
![]() Drives: 2021 Camaro LT1 RS Join Date: Dec 2025
Location: Michigan
Posts: 9
|
IGLA and Range AFM Disabler Compatibility?
Hi all,
I cannot get a clear answer from my local IGLA installer or from the folks who make the Range AFM disabler. Simply stated: In my 2021 stock LT1, can I have an IGLA system installed and also keep the Range AFM disabler active at all times? (The confusion lies in the fact that IGLA disables the OBD port to some degree, but not sure if it is to the point that the Range device will fail to work). I will most appreciate replies based on actual experience, as I have already hear speculation for both yes and no. I do not want to turn the IGLA off and on (in and out of service mode) in order to use the AFM disabler. Thank you for your thoughts.
__________________
2021 LT1 RS
|
|
|
|
|
|
#2 |
![]() ![]() ![]() ![]() ![]() Drives: 2017 2ss 6mt Join Date: Mar 2024
Location: dallas
Posts: 1,539
|
Turn off AFM in the tune. Then you don't need to worry about that side of it.
|
|
|
|
|
|
#3 |
![]() Drives: 2021 Camaro LT1 RS Join Date: Dec 2025
Location: Michigan
Posts: 9
|
"Turn off AFM in the tune. Then you don't need to worry about that side of it."
Appreciate the input. For better worse, as a new Camaro owner I prefer to keep things stock for the time being (while the Range device breaks that rule, it is at least quickly removeable).
__________________
2021 LT1 RS
Last edited by VEEATE; 12-27-2025 at 04:51 PM. Reason: Added quote from previous post. |
|
|
|
|
|
#4 |
![]() ![]() ![]() ![]() ![]() Drives: 2017 2ss 6mt Join Date: Mar 2024
Location: dallas
Posts: 1,539
|
Tuning it out is literally uncheck the box that says DOD- enable. Everything else will stay the same. And if you want to undo it you just check the box again.
|
|
|
|
|
|
#5 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2018 Camaro 2SS A8 Join Date: Jul 2017
Location: East Tennessee
Posts: 13,449
|
Yeah, but we've already paid the entire overhead of tuning (MPVI 2/3/4 plus credits), which he may not be ready to tackle just yet even if his powertrain warranty already expired. And if that's not the case, he probably wants to stretch that warranty to its limits.
__________________
2018 Camaro 2SS — G7E MX0 NPP F55 IO6
735 rwhp | 665 rwtq Magnuson TVS 2300 80mm pulley | Kooks 1 7/8" LT headers | JRE smooth idle Terminator cam | LT4 FS & injectors | TSP forged pistons & rods JMS PowerMAX | DSX flex fuel kit | Roto-Fab CAI | Soler 95mm LT5 TB | 1LE wheels | 1LE brakes | BMR rear cradle lockout | JRE custom tune 1100 - 1/30/18 | 2000 - 1/31/18 3000 - 2/06/18 TPW 2/26/18 3400 - 2/19/18 | 3800 - 2/26/18 4300 - 2/27/18 | 4B00 - 3/01/18 4200 - 3/05/18 | 4800 - 3/14/18 5000 - 3/16/18 | 6000 - 3/19/18 |
|
|
|
|
|
#6 |
![]() Drives: 2024 Camaro 2SS Join Date: Mar 2024
Location: Warren, Michigan
Posts: 4
|
I have a IGLA, Compustar and I use the AFM disabler at all times except for road trips. No problems!
|
|
|
|
|
|
#7 |
![]() Drives: 2021 Camaro LT1 RS Join Date: Dec 2025
Location: Michigan
Posts: 9
|
As in the Range AFM disabler?
__________________
2021 LT1 RS
|
|
|
|
|
|
#8 | |
![]() Drives: 2021 Camaro LT1 RS Join Date: Dec 2025
Location: Michigan
Posts: 9
|
Quote:
__________________
2021 LT1 RS
|
|
|
|
|
|
|
#9 |
![]() Drives: 2021 Camaro LT1 RS Join Date: Dec 2025
Location: Michigan
Posts: 9
|
Thanks for taking the time to make the response, but I have no knowledge of tuning. While what you propose sounds easy for someone with the tools and skill, I have neither when it comes to this.
__________________
2021 LT1 RS
|
|
|
|
|
|
#10 |
![]() Drives: 1987 IROC, 2020 ZL1 Join Date: Nov 2023
Location: Nashvile
Posts: 147
|
If your IGLA is setup to block diagnostics on the OBD port, it only does it when the IGLA is in the "armed" state. Once you authorize the IGLA then the ODB port becomes fully functional again. Well mostly fully functional, believe there is still some additional security around key programming in place. So unless the Range AFM needs to do something when the car is off, when the car is "on" but not running, or when the car is running but before you put it into gear you shouldn't have any issues at all between the IGLA and Range AFM disabler no matter how the IGLA is configured to operate in your vehicle.
|
|
|
|
|
|
#11 |
|
2020 Shadow Gray 2SS
Drives: 2020 2SS - A10, NPP, MRC, CAI Join Date: Dec 2019
Location: SoCal
Posts: 3,816
|
Sounds like you will be just fine, don't over think this...
__________________
2020 SGM 2SS - A10, NPP, MRC, Red Calipers, Black Fender Badge, Footwell Lighting
After delivery: - GMP CAI, GMP Black Strut Tower Brace, MRR017 1LE Wheels, SS Armrest, Black Fuel Door, Stainless Pedals, SS Wheel Caps, GM Splash Guards, DD Smoked LED Markers, Smoked Rear Reflectors, Mishimoto Catch Can, Xpel PPF-Full Front & Rockers, 35% Tint, CeramicPro coated, RST Stainless Brake Lines, Castrol SRF, MSD Plug Wires, Mamo V3 Ported TB Left: My "fun" ride (475 HP). Right: My "work" ride (52,000 HP): a Gulfstream G600. One's top speed is 180 Mph, the other, 620 Mph. BOTH AWESOME to operate... |
|
|
|
|
|
#12 |
![]() Drives: 2024 Camaro 2SS Join Date: Mar 2024
Location: Warren, Michigan
Posts: 4
|
Yes. The Range AFM disabler. Only issue is a slight battery drain if you don't start / drive you car after a week or two. No issues, it does not block the ODP port. The ODP port will not let you read any codes / issues until you put in your IGLA code. When getting my car serviced at the dealership, IGLA provides two FOBs that disable the IGLA when in proximity of the car. I attach one of them to the keys of the car. There also is a app which will allow you to disable the IGLA ( i do not use it ). these are some of the questions that in needed to be answered when I got mine installed. I have had mine for two years ( i think ).
Take the battery out of the FOB when not in use. The FOBs are useful when someone drives your car. No one drives my car but me! |
|
|
|
|
|
#13 | |
![]() ![]() ![]() ![]() ![]() Drives: 2017 2ss 6mt Join Date: Mar 2024
Location: dallas
Posts: 1,539
|
Quote:
On Board Diagnostic |
|
|
|
|
|
|
#14 |
![]() Drives: 18 ZL1 - M6 Join Date: Mar 2019
Location: MI
Posts: 456
|
For all the folks that have IGLA and a Manual Transmission, does your IGLA system allow you to start the vehicle "before" the code is entered? The installer that I talked to did not think that you can do that. Instead, they said the "manual transmission" cars would start like normal, but the engine would shut off once you started to accelerate / drive / move. All videos that I've seen show the code being entered "before" the car/truck could be started. Just curious of what everyone's experience has been. Thanks all
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|