[CNRED]

Hey guys,

My Z had a main bearing failure, dealer is doing a full engine replacement.

This is all covered under a GM warranty. I am having them replace the clutch/ flywheel in addition.

Is there any advice you guys have? Should I replace anything else when they are in there?

All advice/ suggestions are appreciated.

[2004YZFR1]

Maybe to get an upgraded throw out bearing while they are doing the clutch work.

[CNRED]

Called them up yesterday, tech "checked the throw out bearing" and said it looked good. They had already completed the clutch work by the time I got ahold of them.

Appreciate the advice!

[christianchevell]

Used to run a Monster lt1s on my 427 in my 13ss used their billet bearing support instead of stock plastic etc ....parts and it worked well on built engine, I would look to their products to see if anything could be applied, I also did a remote bleeder etc ....look to what may be weak from the factory the aftermarket makes better... I also liked Tick and use them.