You are browsing camaro6 
01-20-2024, 05:14 PM
|
#1 |
 
|
Relay K2 say's Run / Crank
Some of these conversations
any help would be appreciated Last edited by IMCWORTH; 03-22-2024 at 12:12 AM. |
|
|
|
01-20-2024, 11:25 PM
|
#2 |
 Drives: Chevy Camaro SS Join Date: Mar 2022
Location: Inglewood
Posts: 6
|
I'm having the same issue, I can't find anything on it
|
|
|
|
|
01-21-2024, 11:16 AM
|
#3 |
          
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 4,191
|
Take a look at this layout https://fuse-box.info/chevrolet/chev...ses-and-relays
__________________
2020 ZL1LE A10.
LME LT4 390 short block, LME CID Heads, Kong E2650, FBO. 15" conversion, MT ET Street R 325/15. 100 octane: 1045hp/1055tq. 100 octane + Meth (1x10+): 1117 hp/1067 tq |
|
|
|
|
01-21-2024, 05:21 PM
|
#4 | |
|
|
Quote:
Last edited by IMCWORTH; 03-22-2024 at 12:12 AM. |
|
|
|
|
|
01-21-2024, 05:26 PM
|
#5 | |
|
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 4,191
|
Quote:
__________________
2020 ZL1LE A10.
LME LT4 390 short block, LME CID Heads, Kong E2650, FBO. 15" conversion, MT ET Street R 325/15. 100 octane: 1045hp/1055tq. 100 octane + Meth (1x10+): 1117 hp/1067 tq |
|
|
|
|
|
01-21-2024, 05:37 PM
|
#6 | |
|
|
Quote:
Last edited by IMCWORTH; 03-22-2024 at 12:13 AM. |
|
|
|
|
|
01-21-2024, 06:14 PM
|
#7 |
|
Drives: Chevy Camaro SS Join Date: Mar 2022
Location: Inglewood
Posts: 6
|
what about F50 fuel system control module ignition
|
|
|
|
|
01-21-2024, 06:15 PM
|
#8 | |
|
|
Quote:
|
|
|
|
|
|
01-22-2024, 10:50 AM
|
#9 | |
|
|
Quote:
Last edited by IMCWORTH; 03-22-2024 at 12:13 AM. |
|
|
|
|
|
01-23-2024, 09:49 PM
|
#10 |
|
Drives: Chevy Camaro SS Join Date: Mar 2022
Location: Inglewood
Posts: 6
|
hey so after extensive searching, K8 is your fuel pump relay. I unplugged it to check and it checks out car will not start. it'll say fuel prime relay on the fuse box diagram.
|
|
|
|
|
01-24-2024, 11:54 AM
|
#11 |
 |
As far as I know, the remote does not act as an on/off switch. After the relay is armed and the car is running, you are not able to disconnect the relay by hitting the remote again.
I would reach out to them and have a conversation to confirm the intended use case.
__________________
PRIOR CAR:
17' Camaro 2SS A8 Vert Upgrades: Pray MSD IM/95mm TB/E85/Tune / Roto-fab CAI / GM Dark Taillights / LED Turn's with VLED Resisters / LED Reverse Lights / JWM Side Markers / Factory UQT PDR (CTS-V) / BMR DSL, MM010 / TSP 1 7/8 / Front Camera / Eyebrow Harness / Elite Engineering E2-X / AEM Wideband with Aeroforce single pod / HD Radio / OnStar Delete / RPM Roll Bar |
|
|
|
|
01-24-2024, 12:56 PM
|
#12 | |
|
|
Quote:
Last edited by IMCWORTH; 03-22-2024 at 12:13 AM. |
|
|
|
|
|
01-24-2024, 04:35 PM
|
#13 |
|
|
@IMCWORTH check your PM's
__________________
PRIOR CAR:
17' Camaro 2SS A8 Vert Upgrades: Pray MSD IM/95mm TB/E85/Tune / Roto-fab CAI / GM Dark Taillights / LED Turn's with VLED Resisters / LED Reverse Lights / JWM Side Markers / Factory UQT PDR (CTS-V) / BMR DSL, MM010 / TSP 1 7/8 / Front Camera / Eyebrow Harness / Elite Engineering E2-X / AEM Wideband with Aeroforce single pod / HD Radio / OnStar Delete / RPM Roll Bar |
|
|
|
|
05-01-2025, 07:08 AM
|
#14 |
 
Drives: 2022 Camaro V6 2LT Convertible Join Date: Jul 2021
Location: Calgary, Alberta
Posts: 92
|
In the engine compartment fuse block, would anyone know the function of the K2 Relay Run/Crank and the K10 Relay Starter?
Assuming K10 disables the starter motor, what is K2's function? Thanks in advance, while I investigate. |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
