07-16-2023, 02:44 PM | #1 |
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 3,813
|
DSX idler bracket
My blower pulley is 2.75 and I want to change to 2.625 to generate a bit more torque on the hit. I've lowered the shifts to 6500 to lower blower speed.. The belt is not slipping now but I'm thinking it might slip with 2.65 . Kong says an 8-rib belt like a Gates should work if I use a DSX idler bracket to shorten the distance to the pulley. I don't know this bracket. Anyone use it?
https://dsxtuning.com/products/lt4-l...bracket-system
__________________
'20 ZL1LE A10.
LME 390, E2650, FBO. 1116/967. 15" conversion/Weld/MT ET Street R 325/50R15. 100 octane: 1.35/9.25/151 at 3500 ft. (only one pass so far). 100% meth/100 octane: Alky Twin 10+10 MAF; No dyno or ET. |
07-17-2023, 11:55 AM | #2 |
Drives: 2015 Camaro ZL1 Join Date: Oct 2020
Location: Clinton Twp, Michigan
Posts: 285
|
It works as advertised.
|
07-17-2023, 03:20 PM | #3 |
Drives: 2018 Camaro ZL1 A10 Join Date: Feb 2022
Location: Dubai, UAE
Posts: 68
|
Make sure that you get the anodized ones, otherwise the belt will turn grey
|
07-17-2023, 04:59 PM | #4 |
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 3,813
|
__________________
'20 ZL1LE A10.
LME 390, E2650, FBO. 1116/967. 15" conversion/Weld/MT ET Street R 325/50R15. 100 octane: 1.35/9.25/151 at 3500 ft. (only one pass so far). 100% meth/100 octane: Alky Twin 10+10 MAF; No dyno or ET. |
|
|
Post Reply
|
|
|