[Drnick]

Question; when lnstalling these lifting pucks
Do you install with the “lift here” facing
Outwards and the set screw’s facing inwards?
PS. It’s obvious that “lift here” faces outwards
But it came with no instructions (as if if needs any)

[SSEssence]

Yep lift here outwards and screws on the inside, also its impossbile to tighten the screws facing outwards.

[maximus5403]

I have a 1LE and found that they barely extend below the side skirt, they may sit 1/16" below the side skirt.

[Vigilante375]

Originally Posted by maximus5403

I have a 1LE and found that they barely extend below the side skirt, they may sit 1/16" below the side skirt.

Same for the non 1LE. You don't want these things sitting any lower than they need to so they don't catch on anything and rip something off.

Originally Posted by Drnick

Question; when lnstalling these lifting pucks
Do you install with the “lift here” facing
Outwards and the set screw’s facing inwards?
PS. It’s obvious that “lift here” faces outwards
But it came with no instructions (as if if needs any)

You answered your own question.

[Drnick]

Yes, it was quite obvious, but they should’ve been
Made longer,taller, and the slot should’ve been
Not so wide, for a somewhat tighter fit.
PS the stealth pads (on my car) are only 1/4”
Below the skirts.

[joekd]

I think they fit fine, never had a problem getting a floor jack or my quickjacks under them

[WhiteMale]

I used some knockoffs from Amazon, no issues, but like the addon's, I think they they're a bit short for the skirts and such. THey're useful but there's room to improve.

[Vigilante375]

I've used mine for years and have no complaints. I think they are fitted just right for the car.