You are browsing camaro6 
04-17-2021, 03:08 AM
|
#1 |
 Drives: 2019 ZL1 A10 Join Date: Feb 2021
Location: Las Vegas
Posts: 10
|
LT4 Supercharger lid bolt broke!
Hello,
I was installing weapon x supercharger lid and when I went to put back the bolts one of them broke! I will be ordering new bolts but I’m stuck wondering how am I suppose to get that broken bolt out. If I can’t take it out myself will I be able to drive the car to a shop? |
|
|
|
04-17-2021, 06:54 AM
|
#2 |
 Drives: 18 ZL1 1LE Join Date: Apr 2013
Location: Florida
Posts: 705
|
Buy a bolt extractor kit & hopefully that will do the trick. If not, you’ll have to drill the bolt out & retap the threads. You’ll be fine driving it without that one bolt to a shop if you can’t do the work yourself.
|
|
|
|
|
04-17-2021, 01:51 PM
|
#3 |
  
Drives: 2017 Silverado/2017 ZL1 Join Date: Aug 2019
Location: Jax/Palatka FL
Posts: 1,091
|
Depends on where it broke, is there a little stem popping out the hole? Of so you should be able to get it of with a crescent wrench. The tourque on those bolts is measured in inch pounds not foot pounds
__________________
 |
|
|
|
|
04-17-2021, 02:38 PM
|
#4 | |
       
Drives: '20 ZLE Join Date: Jun 2020
Location: Mile High
Posts: 4,195
|
Quote:
__________________
2020 ZL1LE A10.
LME LT4 390 short block, LME CID Heads, Kong E2650, FBO. 15" conversion, MT ET Street R 325/15. 100 octane: 1045hp/1055tq. 100 octane + Meth (1x10+): 1117 hp/1067 tq |
|
|
|
|
|
04-19-2021, 08:09 AM
|
#5 |
Drives: Chevrolet ZL1 Join Date: Jul 2020
Location: S. Milwaukee, WI (The Land of Cheese)
Posts: 41
|
Depending where the lid bolt broke, you may be able to screw it out from the bottom (through the bottom) or screw it towards the top by hand and pulling out that way.
It happened to me on the passenger side, towards the middle of the lid. I bought an extractor kit just in case. |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
