You are browsing camaro6 
10-22-2019, 07:29 AM
|
#1 |
|
TEXIT
Drives: 2019 ZL1 M6 Join Date: Aug 2018
Location: Republic of Texas
Posts: 163
|
Issue with 10" race ramp cribs
It seems my jack only gets up to 19 1/2" inches which was not enough to get the 10" wheel cribs under the wheel. I just used regular jack stands for the 1st oil change. Do you guys with the cribs use wood blocks under each wheel to get the clearance or do I need a jack that gets over 19 1/2" inches?
|
|
|
|
10-22-2019, 09:21 AM
|
#2 |
 
Drives: 2017 ZL1 A10 Join Date: Jul 2014
Location: Atlanta, GA
Posts: 394
|
If only you would have got the 8" cribs like I recommended...
 Now you're stuck either getting a new jack or elevating the jack an inch or two before lifting the car which is sketchy. Last edited by djfury05; 10-22-2019 at 11:22 AM. |
|
|
|
|
10-22-2019, 01:22 PM
|
#3 |
       
Drives: 2019 Silverado Z71 6.2L A10 Join Date: Mar 2017
Location: Grapevine
Posts: 2,075
|
Just get a 2x12 inch board and cut it up to put under the jack.
__________________
Current ride
2019 Silverado Z71 LTZ 6.2L L87 425hp A10, 4 inch BDS Lift with Fox Factory Race 2.5 Coilovers, Borla Cat back (15HP bump), BFG KM3's 33's. Past Rides 2017 M6 Camaro ZL1 Hyper Blue 2016 M6 GT350 White with blue strips 2014 M6 Mustang GT Premium Track Pack Ruby Red 2012 M6 M3 Melbourne Red Metallic |
|
|
|
|
10-22-2019, 08:21 PM
|
#4 |
Drives: 2018 ZL1 Garnet Red Tintcoat A10 Join Date: Jan 2019
Location: NY
Posts: 537
|
What brand jack are you using? I have the Daytona low profile it says max jack height of 23 inches. Haven't tried it yet and was looking into the race ramp blocks for my car. I might have to get the 8in
|
|
|
|
|
10-22-2019, 09:08 PM
|
#5 |
|
TEXIT
Drives: 2019 ZL1 M6 Join Date: Aug 2018
Location: Republic of Texas
Posts: 163
|
Pittsburgh Automotive 3 Ton Heavy Duty Ultra Low Profile Steel Floor Jack with Rapid Pump Quick Lift
Max height is 19 3/4" or so. |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
