You are browsing camaro6 
09-25-2019, 01:22 PM
|
#1 |
 
Drives: ZL1-1LE, 5th Gen COPO Join Date: Aug 2013
Location: Mile High Denver Colorado
Posts: 36
|
Will a 26" DR play nice with a ZLE?
Hello All
I have a rear drag set up from my 13 ZL1. Before I sold the car I had picked up a set of Hoosier P315/30R18. Its a 26" tall tire. https://www.jegs.com/i/Hoosier/522/17342/10002/-1 Long story short, the 13 car even with fuses pulled didn't like the smaller tire. The 2013 car had a 28" tire tho. The ZLE's Stock rears are 26.8" tall. Has anyone here run a 26" tall on a ZLE here??? |
|
|
|
09-25-2019, 01:59 PM
|
#2 |
 
Drives: 2018 ZL1 Coupe NFG M6 Join Date: May 2017
Location: Nolensville, TN
Posts: 618
|
None that I know of, but there's a million SS's running a 26" slick without issue.
__________________
1989 Forumla 350 WS6 <- High School
2000 Trans Am Firehawk <- After High School 2017 Colorado Z71 <- Daily 2018 ZL1 M6 <- Not Daily |
|
|
|
|
09-25-2019, 02:13 PM
|
#3 |
Drives: 2022 Lt1 A10 Join Date: Nov 2015
Location: clark, mo
Posts: 8,862
|
I think it would be tough to hook it.
__________________
2022 Lt1 6.2 A10, Maggie 2300, THPSI Port Inj/10 rib, Rotofab, E, Nickey, SCOL, Griptech, RC Bandits, Hoosiers/MT 9.80@142.96 1.44 60ft, 6.34@112 707/669 RWHP/TRQ. 16SS Maggie 2650 9.41@147 1.35 60ft, 5.99@119. 16 C7 A8 10.90@128 Bolt on stuff
 |
|
|
|
|
09-25-2019, 02:49 PM
|
#4 | |
|
Drives: ZL1-1LE, 5th Gen COPO Join Date: Aug 2013
Location: Mile High Denver Colorado
Posts: 36
|
Quote:
|
|
|
|
|
|
09-26-2019, 11:00 AM
|
#5 |
        Drives: 6th gen Join Date: Aug 2013
Location: US
Posts: 3,703
|
It will work
|
|
|
|
|
09-30-2019, 02:13 PM
|
#6 |
|
Drives: ZL1-1LE, 5th Gen COPO Join Date: Aug 2013
Location: Mile High Denver Colorado
Posts: 36
|
Car ran strong and the computer didn’t know any change...
The Hoosier were horrible. Couldn’t hook to save my life. Was a fun day but hard to race when you can’t hook. |
|
|
|
|
09-30-2019, 03:26 PM
|
#7 |
|
2019 ZL1 1LE MY GOON
Drives: 1980 Z28 Big Red. Join Date: Dec 2018
Location: Stoney Creek
Posts: 2,061
|
What were your times?
|
|
|
|
|
09-30-2019, 03:38 PM
|
#8 |
|
Drives: 2018 ZL1 Coupe NFG M6 Join Date: May 2017
Location: Nolensville, TN
Posts: 618
|
Strange. I dead hooked at CamaroFest on stock tires. What's your power level?
__________________
1989 Forumla 350 WS6 <- High School
2000 Trans Am Firehawk <- After High School 2017 Colorado Z71 <- Daily 2018 ZL1 M6 <- Not Daily |
|
|
|
|
09-30-2019, 04:18 PM
|
#9 |
|
Drives: 6th gen Join Date: Aug 2013
Location: US
Posts: 3,703
|
Unprepped?
|
|
|
|
|
09-30-2019, 05:37 PM
|
#10 | |
|
Drives: ZL1-1LE, 5th Gen COPO Join Date: Aug 2013
Location: Mile High Denver Colorado
Posts: 36
|
Quote:
Best pass was 12.24@117mph. That was with no launch control and still spinning. With Launch control and PTM Race best was 12.79@116. This is a M6 car too. |
|
|
|
|
|
09-30-2019, 05:38 PM
|
#11 | |
|
Drives: ZL1-1LE, 5th Gen COPO Join Date: Aug 2013
Location: Mile High Denver Colorado
Posts: 36
|
Quote:
I'm bone stock. Are you A10 or M6? |
|
|
|
|
|
09-30-2019, 05:39 PM
|
#12 | |
|
Drives: ZL1-1LE, 5th Gen COPO Join Date: Aug 2013
Location: Mile High Denver Colorado
Posts: 36
|
Quote:
Prepped track Hoosiers at from 22 to 15psi. |
|
|
|
|
|
09-30-2019, 09:16 PM
|
#13 |
|
Drives: 18 ZL1 nightfall grey A10 Join Date: Apr 2018
Location: RGV Texas
Posts: 1,527
|
What was your 60’?
I say put psi at 18-20, a good 5 second burnout to warm and clean them up and work on your shifts. Driver mod seems to be what’s needed. |
|
|
|
|
09-30-2019, 10:44 PM
|
#14 | |
|
Drives: ZL1-1LE, 5th Gen COPO Join Date: Aug 2013
Location: Mile High Denver Colorado
Posts: 36
|
Quote:
In all not super disappointed. The DA was 6820 feet. I’m going to find a better tire and give it a go again next season. Seriously feel like I can get it around 12.teen’s or 11.99 on a glory pass if the DA is good. In the summer we can see 9800 to 10k DA. |
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
