You are browsing camaro6 
11-29-2018, 08:36 PM
|
#1 |
 Drives: 1968 Camaro RS Join Date: Sep 2017
Location: Oregon
Posts: 18
|
help with third brake light swap
Just swapped out the third brake light to the smoked out version today, but the adhesive on the top side was barely sticking out so it prevents the light form sitting flush? what would be the best replacement for the adhesive. not sure about what thickness id need
|
|
|
|
11-29-2018, 08:43 PM
|
#2 | |
            
Drives: 2018 Camaro 2SS A8 Join Date: Jul 2017
Location: East Tennessee
Posts: 13,150
|
Quote:
__________________
2018 Camaro 2SS — G7E MX0 NPP F55 IO6
735 rwhp | 665 rwtq Magnuson TVS 2300 80mm pulley | Kooks 1 7/8" LT headers | JRE smooth idle terminator cam | LT4 FS & injectors | TSP forged pistons & rods JMS PowerMAX | DSX flex fuel kit | Roto-Fab CAI | Soler 95mm LT5 TB | 1LE wheels | 1LE brakes | BMR rear cradle lockout | JRE custom tune 1100 - 1/30/18 | 2000 - 1/31/18 3000 - 2/06/18 TPW 2/26/18 3400 - 2/19/18 | 3800 - 2/26/18 4300 - 2/27/18 | 4B00 - 3/01/18 4200 - 3/05/18 | 4800 - 3/14/18 5000 - 3/16/18 | 6000 - 3/19/18 |
|
|
|
|
11-29-2018, 09:54 PM
|
#3 |
|
BYND GARAGE
Drives: 17' 1LT Turbo Join Date: Feb 2016
Location: CA
Posts: 667
|
Easiest mod to do tbh but you probably had it upside down
__________________
|
|
|
|
|
11-29-2018, 10:06 PM
|
#4 | |
|
Drives: 1968 Camaro RS Join Date: Sep 2017
Location: Oregon
Posts: 18
|
Quote:
|
|
|
|
|
|
11-29-2018, 10:15 PM
|
#5 |
 
Drives: 2017 ZL1 A10 Join Date: Jul 2014
Location: Atlanta, GA
Posts: 394
|
Had the same issue first time around. The adhesive that came with it was too thick and it stuck out further than stock even though it was an OEM replacement part. Put some thin double sided 3m tape on it instead and looked much better. Don't have a part # for the tape though sorry. Lowes has a good selection you can browse.
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
