[BlakeR]

Originally Posted by NowaChevyGuy

Installed Skidmark Garage blacked out rear lower reflectors. I love them!!

I have not seen these before. What does it take to install them? Are they still reflective at all?
Thanks

[dfwcowboy]

Originally Posted by BlakeR

I have not seen these before. What does it take to install them? Are they still reflective at all?
Thanks

I have a set I need to install. Doesn't look too difficult.

[dfwcowboy]

I was reminded today I needed to install these.

[coruiz]

Originally Posted by dfwcowboy

I was reminded today I needed to install these.

What did you have to do in order to install them?

[DougCBJ]

Install is easy you have to reach behind from under the car and unscrew. They are only held in with screws on the back side.

[fivewunoh]

Installed this bad ass AA front splitter

[DougCBJ]

these

[dfwcowboy]

Originally Posted by coruiz

What did you have to do in order to install them?

There’s one screw that holds each of them on. The best way to get access to that screw is to remove the two bolts holding the bumper cover onto the two center brackets. You will see them when you look underneath. After those bolts are off you can bend the bumper cover back to provide better access to the screw. It’s not too hard to get off, but getting it back on is a little tricky since there’s not much room to get your fingers in there. If you have a magnetic screwdriver of the right length it would make it much easier.

[chiefmg]

Installed the SEMA grille and ZL1 Addons radiator screen. The screen came without installation instructions so had to do some figuring for that one. Got it all back together and realized I had left out the foam and plastic spacer/energy absorber so had to pull the bumper cover again. Then when that was back together found the passenger marker light was out. Going to do some electrical troubleshooting tomorrow.

[Eptx]

2018 camaro 2ss. Eibach springs, bravado tribute wheels, ikon blade spoiler, black ss emblems. LOVE THIS CAR. I've had it for 6 weeks. Now to decide on which splitter to go with.

[Cgocifer]

Originally Posted by Eptx

2018 camaro 2ss. Eibach springs, bravado tribute wheels, ikon blade spoiler, black ss emblems. LOVE THIS CAR. I've had it for 6 weeks. Now to decide on which splitter to go with.

Looking good! What tail lights are those?

[Eptx]

Originally Posted by Cgocifer

Looking good! What tail lights are those?

Thanks! I just tinted them using VHT Nightshade with some clear. I masked off the brake and reverse portion of the light. Came out pretty nice, eventually ill get the GM smoked tail lights, but this will do for now lol.

[Cgocifer]

Originally Posted by Eptx

Thanks! I just tinted them using VHT Nightshade with some clear. I masked off the brake and reverse portion of the light. Came out pretty nice, eventually ill get the GM smoked tail lights, but this will do for now lol.

Good job.

[ssmike]

Diode Dynamics clear LED sidemarkers.