You are browsing camaro6 
12-21-2015, 05:42 PM
|
#1 |
 
Drives: 2023 ZL1 M6 Rapid Blue Join Date: Aug 2007
Location: Western NY
Posts: 357
|
2.0t LTG for Sale (Blown) Great Project starter
Please see post #2
__________________
2023 Rapid Blue ZL1 M6 | Corsa NPP | Corsa Carbon Fiber Intake | Hardwired Valentine1 Gen 2 | Pro Clip Phone Mount | Last edited by DILLIGAF; 11-09-2016 at 12:35 PM. |
|
|
|
11-08-2016, 01:00 PM
|
#2 |
|
Drives: 2023 ZL1 M6 Rapid Blue Join Date: Aug 2007
Location: Western NY
Posts: 357
|
FS: Blown LTG NEEDS REBUILD perfect spare/project engine
I have a General Motors 4 cylinder 2 liter ecotec turbo engine (code LTG)
This engine was pulled out of my 2014 Cadillac ATS about 1 year ago. The car had less than 7000 miles at time of failure. There is a hole in one of the pistons, most likely caused by an aftermarket tune. the engine did run on the remaining 3 cyclinders. There is another box of smaller parts, maybe vacuum lines and fuel lines, and the intake manifold including throttle body. THERE IS NO TURBO. Asking $1500 obo
__________________
2023 Rapid Blue ZL1 M6 | Corsa NPP | Corsa Carbon Fiber Intake | Hardwired Valentine1 Gen 2 | Pro Clip Phone Mount | |
|
|
|
|
11-09-2016, 12:32 PM
|
#3 |
|
Drives: 2016 1LT RS Camaro; 72 Chevelle Join Date: Apr 2008
Location: Central Point, OR
Posts: 5,685
|
Would you be willing to sell the exhaust manifold off of it?
|
|
|
|
|
12-07-2016, 08:52 PM
|
#4 |
|
Drives: 2023 ZL1 M6 Rapid Blue Join Date: Aug 2007
Location: Western NY
Posts: 357
|
Want to sell the whole thing, as is.
__________________
2023 Rapid Blue ZL1 M6 | Corsa NPP | Corsa Carbon Fiber Intake | Hardwired Valentine1 Gen 2 | Pro Clip Phone Mount | |
|
|
|
|
11-06-2017, 08:14 AM
|
#5 |
 Drives: 2017 Camaro 2.0t Join Date: Oct 2017
Location: Delaware
Posts: 8
|
What tune did u have
|
|
|
|
|
05-25-2018, 07:20 PM
|
#6 |
|
ATS 2.0T
Drives: 2013 Cadillac ATS Join Date: May 2018
Location: Northern New Jersey
Posts: 97
|
If you decide to part it out I’d be very interested in the valve cover no sensors or valves needed will be cut apart for design.
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
