[Soleil]

Originally Posted by Martinjlm

You can also compare your serial number to the list of Fifty s/n and find where it falls in that list.

Originally Posted by Martinjlm

I should have been more specific. The last 8 digits are the serialization. Those numbers would not change sequence based on market of sale. My last 8 are H0103691. My car was built in June 2016, so it was in the window, but I haven’t experienced the problem.

How do you determine the month out of the last 8 digits.

[Martinjlm]

Originally Posted by Soleil

How do you determine the month out of the last 8 digits.

You can’t. But if you look at the list of Fifty serial numbers and compare your last 8 with the last date of others on the list, you can narrow down when yours was built. Since the US buyers got the build card that listed their car’s date of birth, find one with a serial number higher and one with a serial number lower and your car will have been built between those two dates.

[Soleil]

for the explanation but I don’t have the built list

[craigss50]

Originally Posted by jdurhan

They have some tape on front & rear, there is a hard plastic brace that needs to put slid into place on front ones that has one bolt and then 3 pop rivits go through it. I had front wheel cranked all the way, screwed on brace piece, then predrilled the 3 holes using smaller bits until I got up to the 13/64 that instuctions called for. put the 3 rivets in place triggered forst two, the top felt like the inner fender well was pushing away a litttle so I screwed a drywall screw in a few threads and pulled it tight against rivit and triggered it. pulled the red piece of tape off just before I tightened rivits.

The rear ones, remove 3 factory screws, replace with 3 screws supplied. Pretty
easy, I'm 65 with bad arthris in thumbs. Did thumbs hurt afterwards yes, but it wasnt bad. For the back you'll need small 1/4" socket set with torx, without that you would have to pull rear wheels.

Thanks for posting this. Should make my install pretty easy.

[Donrican]

Does anyone know the part numbers for the OEM side rocker? Yes, I know there are others cheaper that may even look better. I just want the OEM rocker. The one for the SS and not the ZL1. I googled the crap out of this and the only thing I found was the entire ground effect package. TIA.

[Soleil]

Yes, as far as I know this is the thing. You have to order the entire aero kit

[LuckyNumberSlevin]

Originally Posted by KyBoy

That's a good looking car man. The black sure looks slick. But...

This is club FIFTY, it's for 50th anniversary edition Camaros. With the H50 package.

Heath

Didn't catch the H50 part, appoligies

[KyBoy]

Originally Posted by LuckyNumberSlevin

Didn't catch the H50 part, appoligies

No apologies neccessary, no big deal.

Heath

[HartfordRacingCaptain]

Originally Posted by LuckyNumberSlevin

Didn't catch the H50 part, appoligies

Between us, they get a little stuck up about it.

[Homer2]

Originally Posted by HartfordRacingCaptain

Between us, they get a little stuck up about it.

its not really " between us" if you type it out loud

[HartfordRacingCaptain]

Originally Posted by Homer2

its not really " between us" if you type it out loud

.

[Kaizer_911]

Originally Posted by HartfordRacingCaptain

.

Sent from my iPhone using Tapatalk

[Martinjlm]

Heath and Adam....do either of you recall where the Fifty registry is?

[KyBoy]

Originally Posted by Martinjlm

Heath and Adam....do either of you recall where the Fifty registry is?

I got a new phone and I forgot all about that app, and what it was called.

Heath