[Soleil]

Originally Posted by Mrfixxit7

Hey guys I have been doing some mods over the winter and hopefully will have everything done in by the end of April.

This is what I have done so far:
-installed the ZL1 taillights and third brake light.
-replaced the sidemarkers
-set of 1LE wheels with MPSS 295/30-20 up front and 335/30-20 on rear
-50th anniversary hotwheels edition steering wheel and shifter

What is next:
-installing ZL1 front brakes and rotors (having the calipers powder coated to match the rears, should be back in a week or so
-ZL1addon rock guards
-ZL1 sides rockers
-ZL1 (FE4) suspension components

Lighting sucks not much room to get good angles while it is in the garage. Hope to get it out of the garage in a couple of weeks

That looks nice. Do you get 335 on the OEM 20x11“ rims? I checked with Michelin and they said max 325 are allowed here in the EU.

[Mrfixxit7]

Originally Posted by Soleil

That looks nice. Do you get 335 on the OEM 20x11“ rims? I checked with Michelin and they said max 325 are allowed here in the EU.

Yes they are the OEM 1LE wheels

[1hprush]

Originally Posted by Mrfixxit7

Yes they are the OEM 1LE wheels

Car looks great! So...how did you get those tire sizes to fit. Does your car have MRC?

[Mrfixxit7]

Originally Posted by 1hprush

Car looks great! So...how did you get those tire sizes to fit. Does your car have MRC?

Yes I have MRC. I rerouted the wiring harness on the driver side and I used a push type fastener to ensure no rubbing (there was an existing hole in the body so I did not have to drill). Next time i have the wheels off I will show a pic. I did not have to do anything to the passenger side but I might use the same push faster just to be safe.

[Mrfixxit7]

Originally Posted by Mrfixxit7

Hey guys I have been doing some mods over the winter and hopefully will have everything done in by the end of April.

This is what I have done so far:
-installed the ZL1 taillights and third brake light.
-replaced the sidemarkers
-set of 1LE wheels with MPSS 295/30-20 up front and 335/30-20 on rear
-50th anniversary hotwheels edition steering wheel and shifter

What is next:
-installing ZL1 front brakes and rotors (having the calipers powder coated to match the rears, should be back in a week or so
-ZL1addon rock guards
-ZL1 sides rockers
-ZL1 (FE4) suspension components

Lighting sucks not much room to get good angles while it is in the garage. Hope to get it out of the garage in a couple of weeks

I forgot to add, as I was test fitting the 6 piston calipers and rotors I tried to put the stock 50th anniversary wheels on and they will not fit. There is not enough offset and they rub on the back side of the wheel. The GMPP 6 piston upgrade is a little smaller than the ZL1 setup but I still doubt they will fit. Needless to say the 1LE rims had no issues.

[KyBoy]

Originally Posted by Mrfixxit7

I forgot to add, as I was test fitting the 6 piston calipers and rotors I tried to put the stock 50th anniversary wheels on and they will not fit. There is not enough offset and they rub on the back side of the wheel. The GMPP 6 piston upgrade is a little smaller than the ZL1 setup but I still doubt they will fit. Needless to say the 1LE rims had no issues.

Valuable info here.

Heath

[Mrfixxit7]

Originally Posted by KyBoy

Valuable info here.

Heath

You could probably get a spacer and it would work. I am not sure what the difference in offset if between the 50th anniversary wheels and the 1LEs but that would be an option.

[KyBoy]

Originally Posted by Mrfixxit7

You could probably get a spacer and it would work. I am not sure what the difference in offset if between the 50th anniversary wheels and the 1LEs but that would be an option.

I'm sure that this could help someone in the future, I divorced my 50th wheels some time ago, remarried the M017s. I asked you for the part numbers of your OEM, I may have to get divorced and remarried a second time hahaha.

Heath

[Soleil]

Does someone have the # Number of the OEM 1LE rims? And maybe a price? Or should I go with the MRR? As they are cheaper? Maybe a project at fall 18.

[Soleil]

I wish all of you a happy eastern

[HartfordRacingCaptain]

Well took the Camaro out last Tuesday and got a good week of use, then put on the GMPP CAI Thursday.

Today the white plague is back though...

[KyBoy]

Originally Posted by HartfordRacingCaptain

Well took the Camaro out last Tuesday and got a good week of use, then put on the GMPP CAI Thursday.

Today the white plague is back though...

That sucks.

Heath

[Kaizer_911]

Originally Posted by Soleil

Does someone have the # Number of the OEM 1LE rims? And maybe a price? Or should I go with the MRR? As they are cheaper? Maybe a project at fall 18.

Front - 23355791
Rear - 23355802

Not sure on price.


Sent from my iPhone using Tapatalk

[KyBoy]

Originally Posted by Kaizer_911

Front - 23355791
Rear - 23355802

Not sure on price.


Sent from my iPhone using Tapatalk

Thanks Adam, I was gonna post them and forgot. I done a little research. I'll shoot Matt a message later and ask.

Heath