[Sinester17]

Originally Posted by Infern0

Nice. I wanna just daily drive like that.

I’ll get the sensors I ordered in next week and I have the reset tool getting delivered tomorrow lol

I don’t see a reason to swap them honestly.

[Sinester17]

Originally Posted by mlee

This is awesome to see.... perfect height too.

I’m happy with how it turned out. I was a little nervous. Not too many cars lowered the same and even less on a 17 with a 28 lol

[TDS]

Looks awesome!

[TDS]

Do you know the off set?

[mlee]

Originally Posted by Sinester17

I guess my pics are just going to upload sideways now??

Fixed now..


...and you're only .6 taller than stock which is perfect, but with being lowered I'm glad you made it. I'm probably headed this route as well.

[Infern0]

Originally Posted by Sinester17

I’ll get the sensors I ordered in next week and I have the reset tool getting delivered tomorrow lol

I don’t see a reason to swap them honestly.

Which sensor/reset tool?

[HDRDTD]

Originally Posted by Infern0

Which sensor/reset tool?

It's an electronic 'tool' that is used to reset your TPMS. It's about the size of a pack of cigarettes. You hold it next to each wheel as you go though the TPMS learning process.
They cost around $50.

[Sinester17]

Originally Posted by TDS

Do you know the off set?

I want to say -41 or -43 I cant remember which exactly.

[Sinester17]

Originally Posted by mlee

Fixed now..


...and you're only .6 taller than stock which is perfect, but with being lowered I'm glad you made it. I'm probably headed this route as well.

I put a tape measure on it and it was about a 0.5 difference between the two. I put 150 miles on the car last night with zero issues. I couldn’t be happier.

And thanks for the fix!

[Sinester17]

Originally Posted by Infern0

Which sensor/reset tool?

I searched the forum and found the part number. I got on amazon and got it for less than 30$ shipped!

[Sinester17]

Looks like I’ve found a triple disk to get next.

Does anyone have any idea what the Factory clutch is rated for? It’s workin well doing some rolls and spirited street driving. But it’s got to be close to tapped out.

Also I’m trying to make plans to get a whipple the first of next year so it’ll be one last thing to have to get when the time comes.

[Victoryred1le]

Originally Posted by TDS

Do you know the off set?

-43 offset

[Rlhay2]

Originally Posted by Sinester17

305/45/17 et Street R’s
Weld s71 17x11(off a c6 z06)
Lowered on afe springs.

Attachment 907464

I did not expect a 17" wheel to fit. Looks good and purposeful!

BTW, nice ZX-14!

[Sinester17]

Originally Posted by Rlhay2

I did not expect a 17" wheel to fit. Looks good and purposeful!

BTW, nice ZX-14!

Thanks! That’s another one of my toys. Pump gas hand clutch on an 80shot. Factory stock motor. Bikes been fun and never let me down!