You are browsing camaro6 
07-05-2023, 08:12 PM
|
#1 |
 
Drives: 2020 Camaro SS 1LE Join Date: Apr 2022
Location: Miami
Posts: 229
|
Camber Bolts
I want to add like a degree of more camber on my car and I saw these and was wondering if anyone has used them before that tracks/autocrosses their car?
https://www.phastekperformance.com/2...mber-81280.htm My car is lowered on H&R springs and I think i have about -3deg on the front, I will double check. |
|
|
|
07-05-2023, 09:49 PM
|
#2 |
         
Drives: 2022 1SS 1LE A10 BCD WCT+PDR Join Date: Mar 2008
Location: Johnstown, PA
Posts: 3,814
|
Those bolts are junk. Stick with the OE bolts
You already have -3* and you want more? Do u have camber plates?
__________________
2022 1SS 1LE A10 BCD WCT+PDR2014 1SS 1LE NPP RECARO SIM-SOLD1995 Z28 M6 GSC PGM-SOLD1975 NOVA COUPE 300HP 350 TH350 FLASH RED-SOLD
"KEEP THE FAITH"-Fbodfather  |
|
|
|
|
07-05-2023, 09:52 PM
|
#3 |
|
Drives: 2020 Rally Green ZL1-1LE Join Date: May 2020
Location: Illinois
Posts: 506
|
If you open the oval hole in the top of the strut so you can tilt the spindle inward, you can gain A LOT!!!! Buy a camber gauge and only remove about .040 and see where you're at.
|
|
|
|
|
07-06-2023, 08:26 PM
|
#4 |
|
I did about .080 camber slot mod and it got me about -3*, but that brings your wheel closer to the strut so you also need to do the strut mod. Results vary depending on wheel size and offset. Highly recommend the Vorshlag camber plates. With the plates I can run -3.5* and wider wheels and get perfect tire wear on track.
strut mod info: https://www.camaro6.com/forums/showthread.php?t=526353
__________________
Mods: MSD, Headers, 95mm TB, high flow cats, full 3" exhaust, SPL, MCS 2-way remotes, sway bars, rear diff lock outs, Sparco racing seats, 6 point harness, CMS roll bar, Nine lives wing, 6" splitter, ACS canards.
www.youtube.com/@Racer_Mike87 |
|
|
|
|
|
|
|
|
Post Reply
|
|
|
