Quote:
Originally Posted by gdgraph
Has anyone used the Sto-N-Sho License Plate Frame with the stock Front Fascia Extension (Front Lip) or the ground effects package (assuming it's the same front lip)?
I ordered the Sto-N-Sho License Plate Frame and was considering getting the Front Fascia Extension from GM, but I'm not sure if they are compatible.
|
I just wanted to follow up on this post to give a final definite answer in case anyone else runs into this question in the future and stumbles upon this thread.
The bottom line answer is NO.
There are two options for the 2016 Camaro SS for the STO N SHOW, Past No. SNS89 for the regular factory bumper, and SNS89A for those that have either the ground effects or factory Front Fascia Extension (Front Lip/Splitter).
I returned the SNS89 that I originally ordered and when I got the SNS89A for the Front Fascia Extension I ordered for my car I noticed that it comes with two screws and two spacers that the SNS89 does not come with. The screws and spacers go into the Front Fascia Extension where as with the SNS89 for the factory bumper you actually end up not getting any screws because you just reuse the 7mm bolts that you remove from the stock front bumper to install the main bracket that mounts onto the car.
Incidentally, just because I was curious, I contacted STO N SHOW and if you end up ordering the SNS89A and don't have the front splitter, that also won't work and you'll need to exchange it for the SNS89 because the SNS89A is different, it has the same base plate, but it is installed reversed and the front plate is slightly different also.
Hope this helps anyone that's trying to order the STO N SHOW and ends up with the wrong one.
(Below is a picture of all the hardware that comes with the SNS89A - for those with the ground effects or front fascia extension)