Hey all,
Reaching out to Too High Psi for more info on a kit.
Thinking port inj and pulley down to 3.7" pulley and see where I'm at. Open to suggestions.
Goals for this move are:
- increase average boost (sucks with 4.13 pulley)
- drop shift point to 6500-6700 (currently around 6950 due to 4.13 pulley and generating enough boost)
- no more mixing at the pump
- run 10.2@135 (why did I pick that number? IDK just because I'm bored with 10.8 I guess 10.2 @ 135 sounds nice right now)
- don't explode engine
Any thoughts or further suggestions? Anyone else running a 3.7"? If so, what kind of numbers do you see?
Update: 2/24/23
Adding links to some of laynlos previous threads for reference:
https://www.camaro6.com/forums/showthread.php?t=608360
https://www.camaro6.com/forums/showthread.php?t=608699
https://www.camaro6.com/forums/showthread.php?t=608988
https://www.camaro6.com/forums/showthread.php?t=609567
https://www.camaro6.com/forums/showthread.php?t=610232
Update 3/1/23
I'll still be updating progress that pertains to my procharger install, but instead of reposting all the same generic stuff that radz28 on the THPSI stuff, just going to link his thread here:
https://www.camaro6.com/forums/showthread.php?t=613426
Update 3/2/23
Haven't assembled anything yet, but here the list of PTFE Hose, PTFE Compatible hose ends, and Misc stuff:
1 - VPE-18966 - 10' of -6 ptfe nylon hose
4 - VPE-16886 - Fuel rail adapter 3/8 to -6AN
4 - VPE-28006 - Female Hose End Straight -6AN
3 - VPE-28906 - Female Hose End 90 Degree -6AN
1 - VPE-28806 - Female Hose End 180 Degree -6AN
1 - VPE-10732 - Female to Female 90 Degree Union -6AN
1 - VPE-10792 - MMF Tee - Tee 2x male (arms) and 1x female (trunk)
1 - VPE-10742 - MFM Tee 1X male (arm) 1x female (arm) 1x male (trunk)
Update 3/4/23
Some fun stuff showed up today. No fittings yet though. As others have noted, everything looks like AAA+ quality.