03-20-2012, 09:09 PM | #1 |
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
Lee's '01 Camaro project/build
So I decided to spend a little money on my car so i bought an SS hood for my Camaro! The hood was originally silver then somebody had a "good" idea to paint it black but they did a crappy job. In fact it was so bad it already started to chip, down to bare fiberglass may i add, all a long on the front lip(pictured below.) So now I'm wet sanding all the layers of paint off and will have to re-prime it with epoxy primer because the previous painter took off the jell coating..
There is also a spot of rust on the rear driver side quarter panel and the mirrors are terribly sun faded into a yellowish orange so I'm going to have to repaint the whole car. I will keep you guys updated on my progress and upload photos daily! Hope you enjoy
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler Last edited by Lee0123567; 03-23-2012 at 10:32 AM. Reason: New photos! |
03-20-2012, 09:27 PM | #2 |
|
Id make sure you get the fiberglass hood struts. If not your hood will begin to crack. The stock struts are made for steel hoods, not fiberglass. VFN sells them for like $40 for 2
http://www.vfnfiberglass.com/site.htm
__________________
2001 Camaro V6
2016 Camaro 2SS |
03-20-2012, 09:30 PM | #3 |
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
The hood came with the original struts so i don't think I'll have a problem with those
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler |
03-20-2012, 09:32 PM | #4 |
|
O ok, as long as the struts are made for a fiberglass hood
__________________
2001 Camaro V6
2016 Camaro 2SS |
03-21-2012, 12:11 AM | #5 | ||
Butter Bar!
Drives: 2011 SS, 1998 Trans Am Join Date: Dec 2010
Location: Patrick AFB, FL
Posts: 1,364
|
Quote:
Quote:
__________________
2011 Camaro SS, White/Orange, LSR Short Throw, CAI
1998 Trans Am, Red, H/C/I, 3200 CircleD Stall, full suspension 2004 GSXR 1k, Matt Mladin Edition |
||
03-21-2012, 02:20 PM | #6 |
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
I'm pretty sure the struts can handle the weight of the hood because we had to take the hood off the car when we bought it.
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler |
03-22-2012, 06:59 PM | #7 |
Maroboy2001 AKA Offset
Drives: Boosted Trans Am Join Date: Oct 2011
Location: Las Cruces, NM
Posts: 1,149
|
Are you painting the hood som?
__________________
|
03-22-2012, 09:52 PM | #8 |
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
No, I'm painting it green to match nothing else on the car. Lol yeah I'm repainting the whole car SOM because the paint is bubbling in a couple places and there's some rust in the rear quarter panel.
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler |
03-23-2012, 05:59 AM | #9 |
|
bright green and orange....that would make a statement!
|
03-23-2012, 09:00 AM | #10 |
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
Dude hellz yeah it would! I should use the synergy green they use on the 5th
gens and paint the scoop itself a black pearl
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler |
03-25-2012, 05:55 PM | #11 |
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
Finished the top side of the hood late Friday night but I was too lazy to post pictures.. so I'm doing it now!
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler |
03-31-2012, 10:04 PM | #12 |
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
Finished priming the bottom of the hood! I'll flip it over, prime top side tomorrow, and then it will be ready for base coat
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler |
04-01-2012, 06:20 AM | #13 |
|
That's going to look great! About 5 years ago my dad had a 2002 sunset orange SS vert. I absolutely love that color. He bought it new in 02 and sold it in 07 with 10k miles.
__________________
2002 Camaro SS- BTR Stage 3, 799 Heads, Bolt on's Tuned by John at Broadview Automotive.. 420hp and 400tq
|
04-01-2012, 07:26 AM | #14 |
#TeamBeckyD
Drives: 2017 HBM 2SS Convertible A8 Join Date: Aug 2008
Location: Apopka, FL
Posts: 10,496
|
Looks good as for the struts I have ad my factory ones from my Z28 on my car for 11 years (55k on the car) with my SS hood never had an issue
__________________
#TeamBeckyD
**FIFTY HBM 2SS VERT** |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tribute car project | navyflyer72 | Member Car Journals | 59 | 02-11-2012 08:26 PM |
Whiteside Customs 2011 Project Showcase | Whiteside Customs | Camaro Photos | Spyshots | Video | Media Gallery | 13 | 06-01-2011 03:33 PM |
MBRP Inc & GM project "Colorado Speed" | MBRP Tech | General Automotive + Other Cars Discussion | 40 | 10-08-2010 07:36 AM |
Ultimate Bolt-On Project or Racers Wet Dream? | JusticePete | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 14 | 04-27-2010 04:01 PM |
Project American Heroes & Route 66 Exotic Coatings | rt66 | Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection | 1 | 10-06-2009 04:58 PM |