You are browsing camaro6 
04-13-2020, 12:31 PM
|
#1 |
 Drives: 2018 ZL1 Join Date: Sep 2016
Location: West Palm Beach
Posts: 194
|
Under load shut off
I previously made a thread thinking I had a misfire https://www.camaro6.com/forums/showt...8#post10736498 but after adding misfire channels to my HOT it did not pick up any misfires. I'm completely lost here. I can gradually ease into the throttle with no issues, but if I jab or hit to full throttle car pops and just shuts off but immediately turns back on.
|
|
|
|
04-13-2020, 01:00 PM
|
#2 |
         Drives: 6th gen Join Date: Aug 2013
Location: US
Posts: 3,702
|
I’m going with a chafed wire. Can u see any maf signal or o2 voltage change as it stalls?
Been a while since I looked but don’t you have the misfire stuff turned off on a built engine? It still records it? Just turns off the MIL?
__________________
‘22 2SS 1LE M6 Summit White - RF, Flexfuel, LT2 intake, 95mm tb, ATI udp, VT ramair, full 28” dragpack - 11.68@122
‘16 1SS M6 LT2 intake + boltons on DR 11.0@126+ (Sold) |
|
|
|
|
04-13-2020, 04:56 PM
|
#3 |
|
Drives: 2018 ZL1 Join Date: Sep 2016
Location: West Palm Beach
Posts: 194
|
I was honestly starting to think the same thing. I'll have to check my hpt, if not on there I'll try to add them.
|
|
|
|
|
04-13-2020, 10:37 PM
|
#4 |
|
Account Suspended
Drives: 2012 2SS CAMARO 45th Join Date: Apr 2011
Location: St. Charles, IL
Posts: 18,663
|
Or a loose ground
|
|
|
|
|
04-14-2020, 06:21 AM
|
#5 | |
|
Drives: 2018 ZL1 Join Date: Sep 2016
Location: West Palm Beach
Posts: 194
|
Quote:
|
|
|
|
|
|
|
|
|
|
Post Reply
|
|
|
