Rate my shopping list
1 Attachment(s)
Looking to either lessen or eliminate the rear wheel hop, along with stiffen up my drivetrain with some new mounts. How's my cart looking? Unless I'm missing something, the only thing i'm debating is switching to an adjustable toe rod instead. All rear end parts are BMR and the motor mounts are Prothane
|
Shoot an email to T.C. at bmrsales on here. He helped me with my setup below and I haven't heard one complaint (I'm away from the car until June).
Koni yellow shocks/struts and BMR Suspension parts: SP019 Lowering Springs Kit (Set of 4 1 Inch Drop) SB030 Sway Bar Kit F & R BK031 Total Bushing Kit Pro Version SFC015 Subframe Connectors DTB004 Drive Shaft Tunnel Brace TR003 Toe Rods Adj TCA026 Trailing Arm TCA028 Lower Control Arms Non-Adj STB014 Strut Tower Bar ELK005 Front End Link Kit FC002 Camber Bolts |
Get the BK024 Full Cradle Bushings - Pro Version!
|
Quote:
|
NICE LIST... BUT IF YOU ARE LOOKING FOR GET RID OF JUST THE rear wheel hop, that list is over kill.....
|
get full cradle bushings. the Delrin are the best. you can do aluminum too. There will be no noise adding solid cradle bushings. cradle bushing make a big difference.
|
Quote:
Quote:
|
the motor mounts wont affect wheel hop but you will need all the rest.
|
Quote:
|
Quote:
|
I notice the bk024 is cheaper than the kit I have in here. Less parts? Not complaining about a smaller bill, just want to make sure I'm not missing out on anything
Sent from my Nexus 6P using Tapatalk |
Quote:
The Cradle Bushings, you can go as hard as you want |
Quote:
Sent from my Nexus 6P using Tapatalk |
All times are GMT -5. The time now is 11:28 PM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.