[RobsCountach]

Originally Posted by cooper1965

Contact Jason@ for information on his TB .

[RobsCountach]

So, what are you folks using for Torque specs on the Throttle body itself ? I understand the clamps are 'hard as you can without breaking them' or they'll pop off !

[ChicagoTommy]

Originally Posted by RobsCountach

So, what are you folks using for Torque specs on the Throttle body itself ? I understand the clamps are 'hard as you can without breaking them' or they'll pop off !

I know it's low, around 7-9ft/lbs. Honestly, snug with a 1/4 inch drive is probably gonna be more than enough. Unless you have a 1/4 inch torque wrench. A 3/8th's torque wrench won't be very accurate at that low of a figure.