11-12-2022, 07:52 PM | #1 |
Drives: 2023 ZL1 vivid Orange Join Date: Jan 2017
Location: Swansboro NC
Posts: 55
|
Installed the 1le spoiler and used epoxy to mount winglets. How to remove the excess?
So i used 3m tape and put some epoxy on the edging part of the winglet. I was trying to clean the excess of the epoxy as much as i can while i was holding it in place. But missed a spot. What is the best way to remove it? I was thinking instead of removing to use black touch up paint and cover it that way. Since the wing is a gloss black. Any suggestions?
|
11-13-2022, 06:59 AM | #2 |
Drives: Wild Cherry LT1 Join Date: Dec 2016
Location: Massachusetts
Posts: 1,925
|
If it were me, I’d use a Dremel with a fine sanding wheel to smooth it out a bit (slow speed, light touch). Then I’d hit it with a Dremel polishing pad (higher speed, light touch). At that point, I’d assess whether or not it needed touch up paint.
|
12-21-2022, 12:07 AM | #3 |
Drives: 1SS Summit White 6 speed Join Date: Jul 2017
Location: Gainesville GA
Posts: 579
|
Sand paper and a razor blade
__________________
16 1SS M6 White
Magnuson 2.3 Heartbeat Roto Fab Solo Performance Cat deletes and Axleback Hurst short shifter #'s coming soon Riaction coilovers 1LE sway bars BMR mm BMR chassis brace Flow one 19" wheels wrapped in Mickey Thompsons 02 Z28 M6 35th anniversary 80k miles T-tops Leather Bolt ons Joy to drive this classic every day! Daily Driver |
|
|
Post Reply
|
|
|