03-04-2021, 02:29 PM | #1 |
Drives: 2016 2SS Join Date: Sep 2018
Location: New Jersey
Posts: 20
|
Splitter Install
So I purchased the EOS front splitter for my car and went to install it and found an issue. Apparently I ran something over and cracked the bottom lip and one of the screw holes is missing from the drive side rear part. That is where the last screw would be placed against the wheel well. Does anybody have any tips for making this work? Im guessing the double sided tape would hold it to a certain extent.
|
03-05-2021, 06:48 AM | #2 |
Hot Camaro
Drives: '20 2SS Convertible 6MT Join Date: May 2020
Location: CT
Posts: 3,534
|
If you can get a solid mating between the splitter material and something solid on the car via tape, and you install it correctly, you should have no issues with it staying put. The predominant force on the splitter will be along the front from wind. Mine is installed (same splitter) with all of the screw hardware as required, the tape that comes pre-installed, and nothing else - I did not drill the front for the additional four screws they give you.
|
03-05-2021, 01:25 PM | #3 | |
Drives: 2016 2SS Join Date: Sep 2018
Location: New Jersey
Posts: 20
|
Quote:
|
|
|
|
Post Reply
|
|
|