01-24-2020, 03:53 PM | #1 |
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,809
|
BMR chassis brace (front of rear cradle) CB008 install
A few pics below. This is an easy install and doesn't require anything special.
Remove the T15 torx screw before removing the 18mm cradle bolt and the 15mm front brace bolts. I decided to replace the cradle bolts to a new non-torque to yield. Tough to find the appropriate bolt but I did find one. The size is M12 x 1.75 130mm. Pic of the bolt package is below and was purchased from Amazon. The bolt is supposed to be 74ft/lbs + 90-105 degrees so I just went with 100ft/lbs. The front two bolts are reused and retorqued to 43ft/lbs. I can't tell if this mod actually made any difference. By the looks of them side-by-side it has to be at least as good as the factory piece.
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
Post Reply
|
|
|