04-15-2018, 12:15 PM | #1 |
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,786
|
Switched power source for gauges
I installed my AEM wideband gauge yesterday. Installation was a snap with one major exception: despite searching for over an hour, I was unable to locate a switched 12v power source inside the car. All 12v wires I checked were not switched. The voltage on all of the switched wires that I could find had been stepped down to 5 - 6 volts. I connected to a 12v unswitched wire and temporarily installed a jury rigged switch under the dash so I could kill power to the gauge. Can anyone help me to locate a switched 12v wire?
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
04-16-2018, 06:53 PM | #2 |
You BCM, under the steering wheel, the black connector there's a small green and violet wire, there are 2 bigger same color wires but you can't use those. Use the smallest one.
__________________
Rotofab, PRAY IM/TB, SE 1 7/8 longtubes full system, SM FLEX FUEL KIT, Custom Exhaust, Mishimoto Catch can, FBO, street tuned.
|
|
04-17-2018, 07:16 AM | #3 |
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,786
|
Thanks! I'll give that a try. I checked a ton of those smaller wires and they all measured 6 volts. I'll check the green and violet one and report back.
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
04-19-2018, 05:35 AM | #4 | |
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,786
|
Quote:
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
|
04-19-2018, 07:57 AM | #5 |
Drives: Hyper Blue 2016 2SS 6M Join Date: Sep 2017
Location: North Ga
Posts: 1,786
|
Hey Lt1z350, check out a thread in the audio section entitled hardwiring a radar detector for more switched power options.
__________________
Baby Blue
2016 Hyper Blue 2SS/6m/MRC/NPP/Silver Rally stripes/ZL1 wheels & brakes/GForce DS and axles/ZLE Cradle Bushings/FE4 ARB front & rear/SEMA Grill/Rotofab dry/95mm TB/Magnuson 2300/Full LT4 fuel system/JMS boost-a-pump/E85 Sensor/Ported CID heads from LME/Cammotion PD cam/Thompson Motorsports forged shortblock/catted Kooks 1 7/8 headers /JRE remote tuned |
04-19-2018, 09:46 PM | #6 |
Drives: 17 Camaro SS 1LE & 16 Sierra AT CC Join Date: Nov 2016
Location: Norman, OK
Posts: 2,424
|
What wire is it and where in the center console?
|
05-16-2018, 08:11 AM | #7 |
Drives: Overkill Supercharged 2016 CamaroV6 Join Date: Mar 2016
Location: Florida
Posts: 982
|
The whole console comes out pretty easy there is a ground bolt under there too you can use I just tapped in under the consoles and ran my own wires out for later use.
__________________
Hyperhawk - 2016 Camaro 2LT RS - First LGX in the 12's and 11's Current record holder 11.0@125
Follow me on Instagram https://www.instagram.com/hyperhawkcamaro/ Youtube https://www.youtube.com/channel/UCHR...-ilSpV3gMQnTuA Supercharged with Overkill Superchargers http://www.v6superchargers.com |
|
|
Post Reply
|
|
|