09-20-2021, 12:56 PM | #1 |
Drives: Chevrolet Camaro 2020 Join Date: Jul 2021
Location: Atlanta, Georgia
Posts: 1
|
Bow Tie
Where can I get a bow tie that black but with the red outline, I’ve seen a few on Amazon but I’m not sure if they’ll be the right ones for a 6th gen 2020 Camaro? Or would it be best to wrap the silver outline in red instead?
|
09-20-2021, 11:58 PM | #2 |
The Wicked Jester
Drives: 2020 Camaro 2SS Orange Crush Vert Join Date: Sep 2012
Location: Orange County, NY
Posts: 87
|
Cupid,
I bought a front/rear set of black Bow Ties. I painted the Front and Rear Bowties to offset the back ground. I could not find what I was looking for so I made my own. For the front - I painted the trim Crush Orange. This orange trim would stand out on the front against the black grill. For the rear - I painted the inside part of the Bow Tie Crush Orange. The trim would be black and offset against the rear trunk panel. I think they came out pretty good. I taped everything off, did 2 coats of Primer Etch, 3 coats of Crush and then 2 coats of Gloss for the finished product. I performed this same process when I painted the Engine Cover & Strut Tower Brace. Good Luck if you go this route. Make it the way you want. Front Overview Front Close Up Rear - Not installed yet
__________________
New Car (His): 2020 Camaro Orange Crush Convertible 2SS
New Car (Hers): 2020 Camaro Satin Steel Metallic Convertible 2LT/RS Redline Package Old Car: 2014 Camaro Summit White 2SS/RS Old Car: 2010 Camaro Inferno Orange 2LT/RS |
|
|
Post Reply
|
|
|