[Bumbleboy92]

Originally Posted by Jarvisfrom85

Has anyone figured out how to use the leds from the light up cup holder and replace the white leds on the radio with them? It’s cheaper to buy two light up cup holders then the footwell light kit.

The light up cup holder I’m pretty sure you’ll have to break to reach the LED chip, I ended up cutting the light tube and attaching my own LED to it. The chip is still sitting in the housing

[chris227]

Originally Posted by Bumbleboy92

The light up cup holder I’m pretty sure you’ll have to break to reach the LED chip, I ended up cutting the light tube and attaching my own LED to it. The chip is still sitting in the housing

Not necessary to break the cup holder to remove the led. There is a small clip holding the led chip housing in place, use a small flathead or pick to pry out the clip a bit and pull up at the same time on the led housing. Once out, easily twist and pull the LED away from the light pipe and your done.

[GrayGhost1LE]

Thanks, Hyper! I followed your instructions and now my 1ss 1le has the spectrum lighting both on top the radio and cupholder lamp.

In my quest to change the interior of my 2019 1ss 1le, I have obtained a cupholder lamp with the 24 color spectrum.

I am looking to sell it, as I don'tneed it and will not burn a hole in your wallet. If anyone needs this item to complete this post pm me.

Good luck and thanks again to all for the awesome job!

[Fire260]

Hey guys, can someone please tell me the size of the light tube that is in the radio/info bezel is?
Thanks

[GrayGhost1LE]

Originally Posted by Fire260

Hey guys, can someone please tell me the size of the light tube that is in the radio/info bezel is?
Thanks

Just guessing, maybe around 1/8"

[Fire260]

Originally Posted by GrayGhost1LE

Just guessing, maybe around 1/8"

Thank you Sir!