You are browsing camaro6 
08-01-2020, 07:11 PM
|
#71 |
   Drives: 2016 Camaro SS Join Date: Sep 2018
Location: Bartlett, TN
Posts: 1,121
|
Here is my 16 with an Anderson Composites 2nd Gen fascia
 Sent from my SM-G955U using Tapatalk |
|
|
|
08-08-2020, 09:48 PM
|
#72 |
     
Drives: 2017 1SS 6spd Join Date: Jan 2011
Location: Utah
Posts: 2,861
|
Has anyone seen this "scrape armor" re-inforcement for the front GM splitter or had any experience with installing it with a splitter?
Can't tell if the two are compatible or if it would offer some help/reinforcement while I'm replacing my original front air dam/splitter? Dealer can't offer any input either...!? Sorry about the poor photo quality! 
Last edited by Ventmaster; 08-13-2020 at 05:38 PM. |
|
|
|
|
08-13-2020, 05:37 PM
|
#73 |
|
Drives: 2017 1SS 6spd Join Date: Jan 2011
Location: Utah
Posts: 2,861
|
Answered my own question... NOT compatible with front facia extention.
|
|
|
|
|
08-15-2020, 09:57 PM
|
#74 |
|
Drives: 2017 1SS 6spd Join Date: Jan 2011
Location: Utah
Posts: 2,861
|
O.K. Last post regarding front splitter- if you're thinking when you go to replace your original (after one too many and an interlude with the curb), that double side 3-M tape is some serious stuff! after removing the 12 screws and drilling out the 4 pop rivets (5mm) I expected the front extension to drop off.
No such luck even after being on there 4 years! Fearing I was gonna damage something else expensive, I tried a run of WD40 followed by good old spray of penetrating oil. After 30 minutes rest (cheese burrito and a beer) it came off without much fight. Cleaned up with paper towels and rubbing alcohol and the new front air dam went on without any issue. Just realized I shoulda took a picture- maybe tomorrow if anyone responds to this post. Have fun! 
|
|
|
|
|
|
|
|
|
Post Reply
|
| Thread Tools | |
|
|
