10-15-2021, 06:23 PM | #1 |
Confused about what i need to install these tail lights
So i have a 2016 1LT with a V6, my tail lights are the factory halogen ones and i’m wanting to install Morimoto XB LED Tail Lights but i’m not exactly sure which harness/harnesses i need in order to avoid any problems like hyper flashing or it draining my battery. I’ve searched for hours but haven’t gotten an exact answer so sorry if this seems like a no brainer question.
https://www.americanmuscle.com/morim...ked-lf401.html |
|
10-15-2021, 09:17 PM | #2 |
BYND GARAGE
Drives: 17' 1LT Turbo Join Date: Feb 2016
Location: CA
Posts: 667
|
__________________
|
10-16-2021, 08:31 AM | #3 | |
Quote:
https://www.gen5diy.com/products/16-...964eada9&_ss=r Ah ok so it is this that i need, now would i only have to order 1 bc it says it comes with 2 sets?? Reason i’m confused is because it only shows A harness with 2 resistors and then what i assume is the resistor for the reverse light |
||
10-16-2021, 08:49 PM | #4 |
BYND GARAGE
Drives: 17' 1LT Turbo Join Date: Feb 2016
Location: CA
Posts: 667
|
You need two harness for each light and yes each harness has two resisters on the harness
__________________
|
|
|
Post Reply
|
|
|