03-18-2019, 10:59 AM | #1 |
Drives: 2017 Camaro 1SS M6 (SOLD) Join Date: Oct 2016
Location: 19518
Posts: 402
|
Launching M6 on drag radials
Looking for some general advice on launching my Whippled M6 SS on M/T ET STREET R BIAS 28x11.5-17. Car makes 650hp to the tire, I have DSS axles and Gforce AL driveshaft, stock clutch.
Any suggestions for launch RPM? In the past on my street tire setup it was just a little RPM say 2500 and an even transfer of throttle and clutch, fighting wheel hop and tire spin. I am thinking I should be able to give it more RPM at the line and a quick smooth clutch release letting the tires do their thing? Any advice for this setup would be appreciated.
__________________
2017 1SS M6 Hyper Blue Metallic NPP, MMR 228 Z/28 replica wheels, Front: 20 x 9, Rear 20 x 11
Stock: 416hp/427tq, 12.21 @ 116.80 Modified 02/2019: Whipple SC w/ 3.500 pulley, LT4 fueling, NW 103 TB, Roto-Fab Big Gulp, Kooks 2" jet coated, full Borla ATAK exhaust, DSS axles, Gforce driveshaft. Tuned by EFX Tuning 688hp/632tq Best 1/4 to date: 10.705 @ 131.92 |
03-18-2019, 11:40 PM | #2 |
Drives: 1SS Summit White 6 speed Join Date: Jul 2017
Location: Gainesville GA
Posts: 578
|
Just heat them up a little more than you would with the street tires. 2500 rpm and a quick slip until you feel it hook
__________________
16 1SS M6 White
Magnuson 2.3 Heartbeat Roto Fab Solo Performance Cat deletes and Axleback Hurst short shifter #'s coming soon Riaction coilovers 1LE sway bars BMR mm BMR chassis brace Flow one 19" wheels wrapped in Mickey Thompsons 02 Z28 M6 35th anniversary 80k miles T-tops Leather Bolt ons Joy to drive this classic every day! Daily Driver |
|
|
Post Reply
|
Thread Tools | |
|
|