After AEM install, screen reads "test"

17MaroSS · 03-30-2021, 09:01 PM

Hello everyone. I just finished installing full bolt ons and after installing a AEM wideband and starting the car, the screen just reads "test". The mode and set buttons don't change anything and there's nothing written about it in the manual. I would appreciate some help here. Thanks in advance!!

Herold Motorsports · 03-31-2021, 01:17 AM

Which aem did you install?

Usually if an aem unit gets stuck on test or heat up mode the power source for the gauge isn’t a strong enough or reliable source. Where are you getting 12v from?

17MaroSS · 03-31-2021, 09:48 AM

Quote:

Originally Posted by Herold Motorsports

Which aem did you install?

Usually if an aem unit gets stuck on test or heat up mode the power source for the gauge isn’t a strong enough or reliable source. Where are you getting 12v from?

It's the aem 30 0334. I didn't know a switch can be weak. Thought it either has power or doesn't cause it's a 12v car. No? This is where i put it

NA18CamaroSS · 03-31-2021, 04:42 PM

Double check your ground. Connect the power directly to the battery. If your power and grounds are good, you may have a defective unit. The next step would be to contact AEM.

20Bluezl1 · 03-31-2021, 06:15 PM

I took my power from the cigarette plug and no issues. I doubt it's a power issue snice you want directly from a fuse. Are you sure your on the correct side of the fuse?

03-30-2021, 09:01 PM	#1
17MaroSS Drives: 17 2SS 6sp Join Date: Jun 2020 Location: Bad Roads, North Jersey Posts: 185	After AEM install, screen reads "test" Hello everyone. I just finished installing full bolt ons and after installing a AEM wideband and starting the car, the screen just reads "test". The mode and set buttons don't change anything and there's nothing written about it in the manual. I would appreciate some help here. Thanks in advance!! Attached Images __________________ FOR SALE 17 2SS 6spd h/c/i/fbo Last edited by 17MaroSS; 03-31-2021 at 09:54 AM.

03-31-2021, 04:42 PM	#4
NA18CamaroSS Drives: 2018 Chevrolet Camaro 2SS 1LE 6M Join Date: Jul 2019 Location: California Posts: 283 View My Garage	Double check your ground. Connect the power directly to the battery. If your power and grounds are good, you may have a defective unit. The next step would be to contact AEM. __________________ Bolt-ons.

03-31-2021, 01:17 AM	#2
Herold Motorsports Drives: 2017 Chevrolet Camaro SS Join Date: Jul 2020 Location: Houston, TX Posts: 31	Which aem did you install? Usually if an aem unit gets stuck on test or heat up mode the power source for the gauge isn’t a strong enough or reliable source. Where are you getting 12v from?

03-31-2021, 06:15 PM	#5
20Bluezl1 Drives: 2020 Zl1 A10 Riverside Blue Join Date: Mar 2020 Location: NJ Posts: 1,223	I took my power from the cigarette plug and no issues. I doubt it's a power issue snice you want directly from a fuse. Are you sure your on the correct side of the fuse?

User Name		Remember Me?
Password