08-27-2020, 10:43 AM | #1 |
Drives: 2020 SS Join Date: Aug 2020
Location: Colorado Springs
Posts: 61
|
Switched power?
Where do you guys tap a hot/switched wire, to power GPS, ect. I'm going to hotwire the GPS to the battery in the trunk or maybe install a fuse block and tap a tail light for switched power.
I've read about the harnesses. I'm looking for a wire to use a Positap on, up front. Thanks.
__________________
2020 2SS
|
08-27-2020, 03:03 PM | #2 | |
Drives: 2017 2SS Convertible Nightfall Gray Join Date: May 2017
Location: Wichita, KS
Posts: 67
|
Quote:
I was able to find both switched and constant power in the A-Pillar on drivers side when I was wiring up my dashcam. Purple: Switched power (I believe it switches off after 5 minutes of turning the car off) Red with white stripe: Constant power Black: Ground Warning: Although there IS switched wiring in Passenger side wiring harness too......ALL power wires are switched on the passenger side wiring harness in A-Pillar...there is NO CONSTANT power on passenger side. You must wire into drivers side as shown if you need to tap into constant power (such as for a dashcam with motion sensor) along with switched power. |
|
08-27-2020, 03:05 PM | #3 |
Drives: 2020 SS Join Date: Aug 2020
Location: Colorado Springs
Posts: 61
|
Very cool, thank you!
|
|
|
Post Reply
|
|
|