09-09-2017, 04:30 PM | #1 |
Drives: 2013 ZL1 and 2019 Ram Laramie Join Date: May 2017
Location: Milwaukee
Posts: 1,259
|
PO15B
Just had my engine light come on. PO15B code. The only mod is a CAI installed 5K miles ago...been running fine with no code until today.
So apparently the code means running lean (O2 sensor, B1S1). Think it's safe to clear the code and run until I do more mods late this fall? |
09-09-2017, 05:15 PM | #2 |
Drives: 2013 ZL1 and 2019 Ram Laramie Join Date: May 2017
Location: Milwaukee
Posts: 1,259
|
I don't know if this is enough to cause the code: I just found two small leaks, one on each of the bottom forward edge of the mufflers. The soot is about 4" in diameter.
|
09-10-2017, 10:19 AM | #3 |
ZL1 Pilot
|
Do you have headers? If so your tuner should have disabled all of the slow response DTC's. Not caused by the muffler drain holes. If you don't have headers, Could be the left front O2 sensor going bad
__________________
GP Tuning 2.5 Cam, RPS Carbon Twin Clutch, Ported Blower, Kook's Headers, Cold Air Inductions CAI, ID850's, 9.17 Lower, 2.5 Upper, JMS BAP, Pedders Front Radius Arm Inserts, Whiteline Subframe Inserts, Tuned by me with HP Tuners Idle Clip Link...........https://www.youtube.com/watch?v=gTL8S9eHwbs |
09-10-2017, 10:28 AM | #4 |
Drives: 2013 ZL1 and 2019 Ram Laramie Join Date: May 2017
Location: Milwaukee
Posts: 1,259
|
I have them, but not yet installed (having them ceramic coated).
Do you think it be the cai (CAI)? That's been installed for 5 months...no issues until yesterday. I will check the O2. Thanks! |
09-10-2017, 10:30 AM | #5 |
ZL1 Pilot
|
No. Replace the sensor
__________________
GP Tuning 2.5 Cam, RPS Carbon Twin Clutch, Ported Blower, Kook's Headers, Cold Air Inductions CAI, ID850's, 9.17 Lower, 2.5 Upper, JMS BAP, Pedders Front Radius Arm Inserts, Whiteline Subframe Inserts, Tuned by me with HP Tuners Idle Clip Link...........https://www.youtube.com/watch?v=gTL8S9eHwbs |
09-10-2017, 12:21 PM | #6 |
Drives: 2013 ZL1 and 2019 Ram Laramie Join Date: May 2017
Location: Milwaukee
Posts: 1,259
|
Thanks ABAD!
|
09-12-2017, 09:12 AM | #7 |
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,808
|
replace the sensor when you install the headers. You will still need a tune to get this code removed by your tuner.
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
09-12-2017, 10:33 AM | #8 |
Drives: 2013 ZL1 and 2019 Ram Laramie Join Date: May 2017
Location: Milwaukee
Posts: 1,259
|
|
09-12-2017, 11:11 AM | #9 |
Big Crow
Drives: '13 ZL1 Join Date: Mar 2017
Location: California
Posts: 1,483
|
To repeat what they said, and add info about tuning if I understand it;
The tune will remove the rear sensors from being considered. They are there to check the operation of the cats. If you keep the cats the sensors might not be adjusted in the tune. With no cats the rear sensors will throw a code error. The front sensors would be wanted to keep the closed loop tune operational. To adjust the rich / lean based on temperatures and altitude and your mods. The front sensors are important. If you have them in error now, besides poor running or bad mpg you could overheat and ruin your cat. I wouldn't really let that go too long myself if you have cats. |
09-12-2017, 11:18 AM | #10 |
Drives: 2013 ZL1 and 2019 Ram Laramie Join Date: May 2017
Location: Milwaukee
Posts: 1,259
|
The only mod I've made is CAI (and SC tank). I didn't think that would throw a code.
I have headers and will have a tune when those are installed (with some other mods). I understood that the sensor might be bad...or the connection or wiring. Not that I have altered the mix that much by adding a CAI. Or am I wrong in that (that a CAI will throw a code)? I understand what you are stating though: if it's a bad sensor...replace it. |
09-13-2017, 06:50 AM | #11 |
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,808
|
Good deal...I wouldn't worry much about the code until all of your mods are installed. Cruising around won't cause any problems with just that code.
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
09-13-2017, 07:09 AM | #12 |
Drives: 2013 ZL1 and 2019 Ram Laramie Join Date: May 2017
Location: Milwaukee
Posts: 1,259
|
|
|
|
|
|