06-17-2019, 02:11 PM | #29 |
Drives: SS 6 speed of course Join Date: Jan 2016
Location: Hilo, HI
Posts: 4,322
|
please snap some pics. OK stupid question, does the Holley fit under the stock hood?
__________________
Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.
|
06-17-2019, 02:28 PM | #30 |
Drives: '17 1ss Join Date: Jun 2017
Location: Borger
Posts: 93
|
What do you need pics of? The holley does not fit under the stock hood
|
06-17-2019, 04:05 PM | #31 |
Drives: SS 6 speed of course Join Date: Jan 2016
Location: Hilo, HI
Posts: 4,322
|
That's what I thought, like to see what it looks like installed... please
__________________
Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.
|
06-29-2019, 01:44 PM | #32 |
Drives: 18’ 1LE H/C/IM Join Date: Jun 2019
Location: Phoenix
Posts: 8
|
Do you plan on modifying your stock hood to get it to fit or going aftermarket? Also where did you pick up the ported high ram? Thanks
|
06-29-2019, 10:28 PM | #33 |
Drives: 2017 Camaro 2SS A8 Join Date: May 2019
Location: USA
Posts: 1,656
|
|
06-30-2019, 02:51 AM | #34 |
Drives: CMaro Join Date: Sep 2018
Location: South Texas
Posts: 101
|
I trapped the same speed with 479hp
|
06-30-2019, 09:16 PM | #35 |
Drives: 17 2SS, 8L90, Cam, Heads, E85 Join Date: Dec 2016
Location: US
Posts: 1,204
|
I was thinking the stock cam table was as good as it gets at 10 degrees? and there are no gains to be had by changing it from stock? (Corvettes and the LTI crate motor have +1 more degree I believe at higher rpms). I haven't tried to mess with mine but I am assuming we need more retard, as in increasing it past 10 at high rpms? (6000+)?
|
|
|
Post Reply
|
|
|