07-31-2018, 02:31 PM | #1 |
Drives: 17 SS a8 Join Date: Feb 2010
Location: omaha
Posts: 1,678
|
People running the cpr or weapon x low side fuel system?
I pretty much copied the cpr set up but with 2 aux pumps.
Is anyone having issues with fuel sloching and uncovering the pick up? I start running into issues at 3/4 of a tank. Under certain conditions I see my fuel pressure drop to nearly nothing. The other day I did a 45mph roll race but with a very abrupt hit (brake boost to ~10psi and then let it rip) and lost all fuel pressure. From a more gentle roll even from a lower speed it flows enough fuel for 18+psi. Seems like the fuel is doing a big flip with the air briefly and uncovering the pick up. I am 99% sure it isn’t any form of vapor lock. I have checked the fuel transfer function and it is constantly pushing fuel to the passenger side as it should. Any ideas? I am thinking about just doing a fuel cell in the drivers rear 1/4 area and feeding the port injection out of that or some kind of a surge tank set up.
__________________
dropped a valve in the 6.2. now running a drop in rods and piston 5.3
best et 5.83@121 with the 5.3 http://www.camaro6.com/forums/showthread.php?t=465472 |
07-31-2018, 04:05 PM | #2 |
Drives: Camaro 17 SS Join Date: Jan 2017
Location: Florida
Posts: 623
|
I have a similar setup to yours but only with a single Bosch 044. My setup has the setup in the rear/lowest point. I have run the system with the low fuel light on and have not had an issue with fuel pressure. I am doing a surge tank for my port injection, but it is because I'm having an issue with leaking.
|
07-31-2018, 04:18 PM | #3 |
Drives: 17 SS a8 Join Date: Feb 2010
Location: omaha
Posts: 1,678
|
It is just a drilled and tapped hole with a fitting threaded into it? No pick up sock or anything like that?
__________________
dropped a valve in the 6.2. now running a drop in rods and piston 5.3
best et 5.83@121 with the 5.3 http://www.camaro6.com/forums/showthread.php?t=465472 |
07-31-2018, 06:56 PM | #4 |
Drives: Camaro 17 SS Join Date: Jan 2017
Location: Florida
Posts: 623
|
Drilled and taped. I don't have a screen. I do have a pre and post filter though. I'm building a surge tank, but that's to address a issue with leaking.
|
08-01-2018, 12:19 PM | #5 |
Drives: 2017 Nightfall Grey Auto 2SS Join Date: Mar 2012
Location: Blue Springs MO.
Posts: 525
|
drilled and bulkhead fittings used no issues that we've seen on the dyno or on the street
|
08-01-2018, 01:16 PM | #6 |
Drives: Camaro 17 SS Join Date: Jan 2017
Location: Florida
Posts: 623
|
|
08-02-2018, 09:25 AM | #7 |
Drives: 2017 Nightfall Grey Auto 2SS Join Date: Mar 2012
Location: Blue Springs MO.
Posts: 525
|
|
08-02-2018, 11:09 AM | #8 |
Drives: Camaro 17 SS Join Date: Jan 2017
Location: Florida
Posts: 623
|
|
|
|
Post Reply
|
|
|