Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > CAMARO6.com General Forums > ZL1 Discussions


BeckyD @ James Martin Chevy


Post Reply
 
Thread Tools
Old 03-23-2021, 12:29 PM   #1
SCSpeed
 
Drives: 17 ZL1
Join Date: Dec 2020
Location: SC
Posts: 62
Rear Camera/Cooled Seats/Heated Seats Not working

2017 ZL1

I just got he car back from bolts mods last week:
Headers
Lower Pulley

Everything was good the first couple days then yesterday jumped in the rear camera screen is blue and service camera message appears. At the same time the heated and cooled seats have stopped working, when you hit the buttons none of the orange lights turn on and the seats do no do anything.

I checked on the fuses per the manual in the engine compartment and trunk, I disconnected the battery to reset the BCM.

I messaged the tuner he has no ideas of the cause or a solution.

Anyone have an insight?
__________________
17 ZL1 M6 Hyper Blue
11 ZR1 Inferno Orange
https://www.youtube.com/@SCSpeed-ms9ok
SCSpeed is offline   Reply With Quote
Old 03-23-2021, 12:44 PM   #2
boosedep3
 
Drives: 2018 SS1LE
Join Date: Dec 2018
Location: Maryland
Posts: 150
Have you checked the harness? Is it possible the headers could have cooked the wires?
boosedep3 is offline   Reply With Quote
Old 03-23-2021, 01:55 PM   #3
ZLE dude
 
Drives: '18 ZL1 1LE
Join Date: May 2020
Location: KY
Posts: 219
Quote:
Originally Posted by boosedep3 View Post
Have you checked the harness? Is it possible the headers could have cooked the wires?
This would be my first thought as well. Look at the wiring harness that runs along the body inside the engine bay under the coolant reservoir on the passenger side. It runs VERY close to the headers. I wrapped my in heat shield and zip tied it back about 2" from where it normally lays to try and give it some breathing room from the headers. This is looking straight down where the coolant reservoir would be sitting.
Attached Images
 
__________________
2018 ZL1 1LE - Summit White, PDR, Rotofab CAI, 95mm TB, CSP 2" catless LT's, JMS Voltage Booster, AEM X-series WB, DSX flex fuel sensor, Banks Data Monster, Tuned by Ted Jannetty, 5% Tint, Blackvue DR900S-2CH, Diode Dynamics lighting, IGL Kenzo ceramic coating
ZLE dude is offline   Reply With Quote
Old 03-23-2021, 02:10 PM   #4
SCSpeed
 
Drives: 17 ZL1
Join Date: Dec 2020
Location: SC
Posts: 62
Quote:
Originally Posted by ZLE dude View Post
This would be my first thought as well. Look at the wiring harness that runs along the body inside the engine bay under the coolant reservoir on the passenger side. It runs VERY close to the headers. I wrapped my in heat shield and zip tied it back about 2" from where it normally lays to try and give it some breathing room from the headers. This is looking straight down where the coolant reservoir would be sitting.
Appreciate that I will check it ASAP!
__________________
17 ZL1 M6 Hyper Blue
11 ZR1 Inferno Orange
https://www.youtube.com/@SCSpeed-ms9ok
SCSpeed is offline   Reply With Quote
Old 03-23-2021, 02:20 PM   #5
ZLE dude
 
Drives: '18 ZL1 1LE
Join Date: May 2020
Location: KY
Posts: 219
Quote:
Originally Posted by SCSpeed View Post
Appreciate that I will check it ASAP!
Sounds good. I hope I'm wrong.
__________________
2018 ZL1 1LE - Summit White, PDR, Rotofab CAI, 95mm TB, CSP 2" catless LT's, JMS Voltage Booster, AEM X-series WB, DSX flex fuel sensor, Banks Data Monster, Tuned by Ted Jannetty, 5% Tint, Blackvue DR900S-2CH, Diode Dynamics lighting, IGL Kenzo ceramic coating
ZLE dude is offline   Reply With Quote
Old 03-23-2021, 05:00 PM   #6
PROMETHEUS

 
PROMETHEUS's Avatar
 
Drives: 2019 ZL-1, Shadow Gray, Sold
Join Date: Jan 2019
Location: Fredericksburg, VA
Posts: 1,390
Quote:
Originally Posted by boosedep3 View Post
Have you checked the harness? Is it possible the headers could have cooked the wires?
+1, most likely melted a wiring harness. Too many things went wrong at the same time for it to be anything else, IMHO!
PROMETHEUS is offline   Reply With Quote
 
Post Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:02 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.