Homepage Garage Wiki Register Members List Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > CAMARO6.com General Forums > 2016+ Camaro: 6th Gen Camaro general forum


Emblempros


Post Reply
 
Thread Tools
Old 04-04-2016, 08:01 PM   #1
z28guy30
 
z28guy30's Avatar
 
Drives: 2016 camaro 1ss
Join Date: May 2011
Location: hawaii
Posts: 326
What is your best 0-60 time stock?

So I tried using the built in 0-60 timer today and was a bit disappointed in my results. I ran it three times and my best run was 5 seconds flat. Does anyone have any tips to achieve better times? My understanding is these cars will do 4.0-4.2 0-60.

Location: Hawaii
Temperature: 77 degrees
Run 1: 5.1 secs TCS off/Track Mode/Stabiltrak off (Didn't load)
Run 2: 5.0 secs TCS off/Track Mode/Stabiltrak off (launched at 2500 RPMs)
Run 3: 5.0 secs TCS on/ Track Mode/Stabiltrak on (Didn't load)
__________________
2016 Camaro SS, Summit White, A8, MRC, Rally Stripes, Black Bowties.
z28guy30 is offline   Reply With Quote
Old 04-04-2016, 08:04 PM   #2
mcsoul

 
Drives: Want a gen 6
Join Date: Jan 2013
Location: 75089
Posts: 1,032
The manual says 1/2 throttle until 35mph, then full throttle.
Did you try that?
mcsoul is offline   Reply With Quote
Old 04-04-2016, 08:14 PM   #3
z28guy30
 
z28guy30's Avatar
 
Drives: 2016 camaro 1ss
Join Date: May 2011
Location: hawaii
Posts: 326
That may explain it. I went full throttle the entire way.
__________________
2016 Camaro SS, Summit White, A8, MRC, Rally Stripes, Black Bowties.
z28guy30 is offline   Reply With Quote
Old 04-04-2016, 08:27 PM   #4
mcsoul

 
Drives: Want a gen 6
Join Date: Jan 2013
Location: 75089
Posts: 1,032
Of course they are trying to keep you out of the ditch, so really I think you should use half throttle as a starting point. Then add throttle to the edge of adhesion, where the tires let out like three light chirps to 35mph, then floor it. Also not all surfaces can produce good times, shop around and look for a road that can handle more throttle earlier with TCS off/Track Mode/Stabiltrak off.
mcsoul is offline   Reply With Quote
Old 04-04-2016, 08:52 PM   #5
Blam2526
 
Blam2526's Avatar
 
Drives: 16 2SS
Join Date: Jan 2016
Location: Ft Knox, ky
Posts: 199
I tried today as well. Got it to 5.1 with a fair amount of wheel spin. Attempted launch control, is there supposed to be a message that says "launch control ready" or something? Only message I saw was when I put it into competitive mode. I'm pretty sure launch worked... I had clutch to the floor, wheel straight, floored it revs settled at about 35 and quickly let the clutch out (didn't side step it). I didn't get an actual time on the launch run, had a different screen up instead of the timer. The 5.1 was with all traction control on, just a user induced launch.
__________________
2/3/16 Ordered #TFKDC9
3/23/16 Took delivery!
Hyper Blue 2SS, Jet black int, NPP, MRC, 6MT, 56V rims, NAV, Sunroof, Black Bow ties, painted engine cover, black tail lights and side markers, Lime green calipers, custom painted SS badges, Stillen body kit, Borla ATAK and Cat delete Xpipe
Blam2526 is offline   Reply With Quote
Old 04-04-2016, 09:22 PM   #6
Techn9cian805
The BEAST
 
Techn9cian805's Avatar
 
Drives: '16 2SS, '89 Wife
Join Date: May 2015
Location: Central Coast, CA
Posts: 2,038
4.7 without any assists. With the launch control i got a 4.8. Thats cool to me lol.
__________________
Scarlet: 3/3/16: 2SS Red Hot, M6,
Instagram: @luis_what_it_is
Techn9cian805 is offline   Reply With Quote
Old 04-04-2016, 09:23 PM   #7
oldman


 
Drives: SS 6 speed of course
Join Date: Jan 2016
Location: Hilo, HI
Posts: 4,137
I can get consistent 4.0 or better...



waiting on tune and cat delete...

this is a zero to 80 run (top of 2nd).
__________________
Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.
oldman is offline   Reply With Quote
Old 04-04-2016, 09:32 PM   #8
BFella
 
BFella's Avatar
 
Drives: 16' Supercharged 1SS
Join Date: Apr 2014
Location: Scottsdale, AZ
Posts: 651
4.6 seconds on a cold night without warming up my tires and traction control on and only in sports mode.
BFella is offline   Reply With Quote
Old 04-04-2016, 09:39 PM   #9
formoutofchaos

 
Drives: Camaro 2017 1LE
Join Date: Feb 2016
Location: Atlanta
Posts: 1,154
i used to get that with a 97 supra turbo, dam i hope it runs 4.3 at least with a decent manual driver...... how else can we smoke the new GT
formoutofchaos is offline   Reply With Quote
Old 04-04-2016, 09:42 PM   #10
oldman


 
Drives: SS 6 speed of course
Join Date: Jan 2016
Location: Hilo, HI
Posts: 4,137
Quote:
Originally Posted by formoutofchaos View Post
i used to get that with a 97 supra turbo, dam i hope it runs 4.3 at least with a decent manual driver...... how else can we smoke the new GT
it has already been tested at 4.0 flat, a decent manual driver will beat that...
__________________
Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.
oldman is offline   Reply With Quote
Old 04-04-2016, 09:42 PM   #11
BFella
 
BFella's Avatar
 
Drives: 16' Supercharged 1SS
Join Date: Apr 2014
Location: Scottsdale, AZ
Posts: 651
Quote:
Originally Posted by formoutofchaos View Post
i used to get that with a 97 supra turbo, dam i hope it runs 4.3 at least with a decent manual driver...... how else can we smoke the new GT
I've raced 3 new GT's and not one of them was within a car length of me and my best 0-60 is 4.6..... sooooooo
BFella is offline   Reply With Quote
Old 04-04-2016, 09:58 PM   #12
oldman


 
Drives: SS 6 speed of course
Join Date: Jan 2016
Location: Hilo, HI
Posts: 4,137
Quote:
Originally Posted by BFella View Post
I've raced 3 new GT's and not one of them was within a car length of me and my best 0-60 is 4.6..... sooooooo

here you go a light M6

http://www.motortrend.com/news/2016-...rd-mustang-gt/

0-60 4.0
__________________
Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.
oldman is offline   Reply With Quote
Old 04-04-2016, 11:04 PM   #13
xmonger
 
xmonger's Avatar
 
Drives: Too many
Join Date: Mar 2016
Location: NJ
Posts: 44
Quote:
Originally Posted by oldman View Post
I can get consistent 4.0 or better...



waiting on tune and cat delete...

this is a zero to 80 run (top of 2nd).
Where you running downhill to get a 3.7? Seems too good to be true with the stick.
xmonger is offline   Reply With Quote
Old 04-04-2016, 11:14 PM   #14
AN0NYM0US
 
Drives: .
Join Date: Dec 2015
Location: Michigan
Posts: 256
Not me but I found it on YouTube

http://youtu.be/P7bYmjRCeZ8
AN0NYM0US is offline   Reply With Quote
 
Post Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:55 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2020, vBulletin Solutions, Inc.